DataSheet39.com

What is ENH057Q1-600?

This electronic component, produced by the manufacturer "WEDC", performs the same function as "(ENH057Q1-xxx) Color TFT-LCD Module Features GENERAL DESCRIPTION".


ENH057Q1-600 Datasheet PDF - WEDC

Part Number ENH057Q1-600
Description (ENH057Q1-xxx) Color TFT-LCD Module Features GENERAL DESCRIPTION
Manufacturers WEDC 
Logo WEDC Logo 


There is a preview and ENH057Q1-600 download ( pdf file ) link at the bottom of this page.





Total 16 Pages



Preview 1 page

No Preview Available ! ENH057Q1-600 datasheet, circuit

www.DataSheet4U.com
White Electronic Designs
Display Systems Division
ENH057Q1-350/450/600
ENH057Q1-350/450/600 Color TFT-LCD Module Features
GENERAL DESCRIPTION
Panelview provides optically enhanced solutions to the
standard Sharp LQ057Q3DC02 color active matrix LCD
module. The first enhancement is an index matching (IM)
film lamination to the front surface of the display polarizer.
The IM film is available in two surface treatments - IM/Clear
and IM/110 (a 10% diffusion).The second enhancement is
the incorporation of a reflective polarizer (RP) to improve
brightness by up to 40%. The third enhancement is
the addition of prism films (RPp) further increasing the
brightness of the display. The module is composed of a
color TFT-LCD panel, driver ICs, control circuit, power
supply circuit and a backlight unit. Graphics and text can
be displayed on a 320 X 3 X 240 dot panel with 262,
144 color by supplying 18 bit data signal (6bit/color), four
timing signals.
The TFT-LCD panel used for this module is a low-reflection
and higher-color-saturation type. Therefore, this module
is also suitable for multimedia use. Viewing angle is 12
o'clock direction. This module is the type of wide viewing
angle and high brightness 350cd/m2. It has horizontal
display mode and vertical display mode.
Backlight-driving DC/AC inverter is not built in this
module.
Panelview assumes no responsibility for any damage
resulting from the use of the device which does not
comply with the instructions and the precautions specified
in these specification sheets. Panelview does assume the
responsibility for the warranty of the enhanced product.
Parameter
Display size
Active area
Pixel format
Pixel pitch
Pixel configuration
Display mode
Unit outline dimensions (1)
Mass
Surface treatment
Note:
1. Excluding backlight cables.
MECHANICAL SPECIFICATIONS
Specifications
14.4 (5.7") Diagonal
115.2 (H) x 86.4 (V)
320 (H) x 240 (V)
(1 pixel=R+G+B dots)
0.360 (H) x 0.360 (V)
R,G,B vertical stripe
Normally white
144.0 (W) x 104.6 (H) x 13.0(D)
220 ± 20
IM/Clear (glossy) or IM/110 and hardcoat 3H
Units
cm
mm
pixel
-
mm
-
-
mm
g
-
Note: This measurement is typical, and see Fig. 3 for details.
White Electronic Designs Corp. reserves the right to change products or specifications without notice.
Original specifications created by Sharp.
September 2003
Rev. 0
1 Display Systems Division • Hillsboro, OR • (503) 690-2460 • www.wedc.com

line_dark_gray
ENH057Q1-600 equivalent
White Electronic Designs
Display Systems Division
ENH057Q1-350/450/600
2. VCC=3.3V V/Q= "H"
Typical current situation
Maximum current situation
:64-gray bar pattern
Timing: Typical signal
:Vertical stripe pattern by GS0 and GS42 signal on every other pixel.
(This pattern is used temporarily)
Timing: Typical signal
GSO GS1 GS2
GS62 GS63
GS42
GS0
Typical Current Situation
Maximum current situation
3. CK, RO~R5, GO~G5, BO~B5, HSYNC, VSYNC, ENAB, R/L, U/D, V/D
4. CK, RO~R5, GO~G5, BO~B5, HSYNC, VSYNC, R/L, U/D
5. ENAB, V/D
BACKLIGHT DRIVING SECTION
The backlight system is an edge-lighting type with single CCFT (Cold Cathode Fluorescent Tube).
The characteristics of a single lamp are shown below.
tA=25°C
Parameter
Lamp Voltage
Lamp current
Lamp power consumption
Lamp frequency
Kickoff voltage tA=25°C
tA=30°C
Symbol
VL7
IL
WL
FL
VS
MIN
620
4.5
-
30
-
-
TYP
690
5.0
3.5
-
-
-
(Inverter: HIU-288 [Output Condenser 22pF] Harison Electric Co., LTD.)
MAX
760
5.5
-
60
1350
1470
Unit
Vrms
mArms
W
KHz
Vrms
Vrms
Remark
IL=6.5mArms
normal operation
-
(6)
Sealed is connected to
GND
6. Lamp frequency may produce interference with horizontal synchronous frequency, and this may cause horizontal beat on the display. Therefore, lamp frequency shall be
detached as much as possible from the horizontal synchronous frequency and from the harmonics of horizontal synchronous to avoid interference. In case of such usage under
lower temperature environments, periodic lamp exchange by Panelview is recommended.
White Electronic Designs Corp. reserves the right to change products or specifications without notice.
Original specifications created by Sharp.
September 2003
Rev. 0
5 Display Systems Division • Hillsboro, OR • (503) 690-2460 • www.wedc.com


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for ENH057Q1-600 electronic component.


Information Total 16 Pages
Link URL [ Copy URL to Clipboard ]
Download [ ENH057Q1-600.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
ENH057Q1-600The function is (ENH057Q1-xxx) Color TFT-LCD Module Features GENERAL DESCRIPTION. WEDCWEDC

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

ENH0     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search