DataSheet39.com

What is BA2904SFVM?

This electronic component, produced by the manufacturer "ROHM Semiconductor", performs the same function as "Ground Sense Operational Amplifiers".


BA2904SFVM Datasheet PDF - ROHM Semiconductor

Part Number BA2904SFVM
Description Ground Sense Operational Amplifiers
Manufacturers ROHM Semiconductor 
Logo ROHM Semiconductor Logo 


There is a preview and BA2904SFVM download ( pdf file ) link at the bottom of this page.





Total 30 Pages



Preview 1 page

No Preview Available ! BA2904SFVM datasheet, circuit

Datasheet
Operational Amplifiers
Ground Sense Operational Amplifiers
BA10358xx, BA10324Axx, BA2904xxx, BA2904Sxxx, BA2904Wxx
BA2902xx, BA2902Sxx
General Description
General purpose BA10358 / BA10324A and high
reliability BA2904 / BA2902 integrate two or four
independent Op-Amps on a single chip and have some
features of high-gain, low power consumption, and
wide operating voltage range of 3V to 36V (single
power supply ).
BA2904W have low input offset voltage(2mV max.).
Features
Operable with a single power supply
Wide operating supply voltage range
Input and output are operable GND sense
Low supply current
High open loop voltage gain
Wide temperature range
Application
Current sense application
Buffer application amplifier
Active filter
Consumer electronics
Key Specification
Wide Operating Supply Voltage (single supply):
BA10358/BA10324A
+3.0V to +32.0V
BA2904/BA2902
+3.0V to +36.0V
Wide Temperature Range:
BA10358/ BA10324A
-40°C~+85°C
BA2904S/ BA2902S
-40°C~+105°C
BA2904/ BA2902
-40°C~+125°C
BA2904W
-40°C~+125°C
Input Offset Voltage:
BA10358/ BA10324A
7mV (Max)
BA2904S/ BA2902S
7mV (Max)
BA2904/ BA2902
7mV (Max)
BA2904W
2mV (Max)
Low Input Bias Current:
BA10358
45nA (Typ)
BA10324A
20nA (Typ)
BA2904S/ BA2902S
20nA (Typ)
BA2904/ BA2902
20nA (Typ)
BA2904W
20nA (Typ)
Packages
SOP8
SOP-J8
SSOP-B8
MSOP8
SOP14
SOP-J14
SSOP-B14
W(Typ) x D(Typ) x H(Max)
5.00mm x 6.20mm x 1.71mm
4.90mm x 6.00mm x 1.65mm
3.00mm x 6.40mm x 1.35mm
2.90mm x 4.00mm x 0.90mm
8.70mm x 6.20mm x 1.71mm
8.65mm x 6.00mm x 1.65mm
5.00mm x 6.40mm x 1.35mm
Selection Guide
Normal
High-reliability
Dual
Quad
Dual
Quad
Output Current
Source/Sink
20mA/20mA
35mA/20mA
30mA/20mA
30mA/20mA
Input Offset
Voltage
7mV
7mV
7mV
2mV
7mV
Maximum operating temperature
+85°C
+105°C
+125°C
BA10358F
BA10358FV
BA10358FJ
BA10324AF
BA10324AFV
BA10324AFJ
BA2904SF
BA2904SFV
BA2904SFVM
BA2902SF
BA2902SFV
BA2904F
BA2904FV
BA2904FVM
BA2904WF
BA2904WFV
BA2902F
BA2902FV
Product structureSilicon monolithic integrated circuit This product is not designed protection against radioactive rays.
www.rohm.com
© 2013 ROHM Co., Ltd. All rights reserved.
TSZ2211114001
1/52
TSZ02201-0RAR0G200130-1-2
23.Jan.2014 Rev.003

line_dark_gray
BA2904SFVM equivalent
BA10358xx, BA10324Axx, BA2904xxx, BA2904Sxxx, BA2904Wxx
BA2902xx, BA2902Sxx
Datasheet
Absolute Maximum Ratings (TA=25°C)
BA2904, BA2902
Parameter
Symbol
BA2904S
BA2902S
Ratings
BA2904, BA2904W
BA2902
Unit
Supply Voltage
Power dissipation
Differential Input Voltage(Note 16)
VCC-VEE
SOP8
SSOP-B8
PD MSOP8
SOP14
SSOP-B14
VID
+36
775(Note 10,15)
625(Note 11,15)
600(Note 12,15)
560(Note 13,15)
870(Note 14,15)
+36
V
mW
V
Input Common-mode Voltage Range
Input Current(Note 17)
VICM
II
(VEE-0.3) to (VEE+36)
-10
V
mA
Wide Operating Supply Voltage
Vopr
+3.0 to +36.0
V
Operating Temperature Range
Topr
-40 to +105
-40 to +125
°C
Storage Temperature Range
Tstg
-55 to +150
°C
Maximum Junction Temperature
TJmax
+150
°C
(Note 10) To use at temperature above TA=25°C reduce 6.2mW.
(Note 11) To use at temperature above TA=25°C reduce 5.0mW.
(Note 12) To use at temperature above TA=25°C reduce 4.8mW.
(Note 13) To use at temperature above TA=25°C reduce 4.5mW.
(Note 14) To use at temperature above TA=25°C reduce 7.0mW.
(Note 15) Mounted on a FR4 glass epoxy PCB 70mm×70mm×1.6mm (Copper foil area less than 3%).
(Note 16) The voltage difference between inverting input and non-inverting input is the differential input voltage.
Then input terminal voltage is set to more than VEE.
(Note 17) An excessive input current will flow when input voltages of less than VEE-0.6V are applied.
The input current can be set to less than the rated current by adding a limiting resistor.
Caution: Operating the IC over the absolute maximum ratings may damage the IC. The damage can either be a short circuit between pins or an open circuit
between pins and the internal circuitry. Therefore, it is important to consider circuit protection measures, such as adding a fuse, in case the IC is operated
over the absolute maximum ratings.
www.rohm.com
© 2013 ROHM Co., Ltd. All rights reserved.
TSZ2211115001
5/52
TSZ02201-0RAR0G200130-1-2
23.Jan.2014 Rev.003


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for BA2904SFVM electronic component.


Information Total 30 Pages
Link URL [ Copy URL to Clipboard ]
Download [ BA2904SFVM.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
BA2904SFVThe function is Ground Sense Operational Amplifiers. ROHM SemiconductorROHM Semiconductor
BA2904SFVMThe function is Ground Sense Operational Amplifiers. ROHM SemiconductorROHM Semiconductor

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

BA29     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search