|
|
PDF CLAA154WB08AD Data sheet ( Hoja de datos )
| Número de pieza | CLAA154WB08AD | |
| Descripción | Display Module | |
| Fabricantes | CHUNGHWA PICTURE TUBES | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de CLAA154WB08AD (archivo pdf) en la parte inferior de esta página. Total 24 Páginas | ||
|
No Preview Available !
Chunghwa Picture Tubes, Ltd.
Technical Specification
To :
Date : 2007/06/26
CPT TFT-LCD
CLAA 154WB08A
D
ACCEPTED BY：
www.DataSheet.net/
APPROVED BY
黃奕凱
CHECKED BY
劉益群
PREPARED BY
趙志方
Prepared by : Design General Division
CHUNGHWA PICTUER TUBES, LTD.
No. 1, Huaying Rd., Sanho Tsun, Lungtan Shiang, Taoyuan, Taiwan, 325, R.O.C.
TEL: +886-3-4805678 FAX: +886-3-4800589
Doc. No: CLAA154WB08A D-STUDIO –V1- 2007/06/26
Issue Date: 2007/06/26
www.yslcd.com.twDatasheetpdf-http://www.DataSheet4U.co.kr/
1 page  
CHUNGHWA PICTUER TUBES, LTD.
TECHNICAL SPECIFICATION
Title：CLAA154WB08A
Technical Specification
Doc. No：
Version：
Issue Date ：
V1
2007/06/26
The following are maximum value, which if exceeded, may cause faulty operation or damage to the unit.
ITEM
Power Supply Voltage for LCD
Lamp voltage
Lamp current
Lamp frequency
Operation Temperature
Storage Temperature
Delayed Discharge Time
【Note】
SYMBOL
VCC
VL
IL
FL
Top
Tstg
TD
MIN.
0
630
2
40
0
-25
--
MAX.
4.0
945
6.5
80
50
65
1
UNIT
V
Vrms
mArms
kHz
℃
℃
sec
REMARK
*1). 2)
*3). 4). 5). 6)
*3). 4). 5)
*7)
*1) Product life-time relate to lamp current, please operate production follow statement at page 9
〝(b)back light〞.
*2) When lamp current over the definition of absolute max, product life-time will decay rapidly or operate
unusual.
*3) The relative temperature and humidity range are as below sketch, 90%RH Max. (Ta≦40℃)
*4) The maximum wet bulb temperature ≦39℃(Ta＞40℃) and without dewing.
*5) If product in environment which over the definition of the relative temperature and humidity out of
range too long, it will affect visual of LCD.
*6) If you operate LCD in normal temperature range, the center surface of panel should be under 60℃.
*7) Delay discharge time test condition ：Starting lampwww.DataSheet.net/ voltage=1650Vrms. (please follow statement at
page 9 〝 (b) back light〞
Before test TD, lamp should operate at least 1min, and lamp current should follow typical lamp current
specification. To place panel at room temp. (25±2℃) below for 24hrs, and then to measure TD with the same
starting lamp voltage in dark room.
90
80
60
40
20
5
3.
-25
ELECTRICAL
0 20
CHARACTTeEmRpeIraStuTreIC(°CS)
(A) TFT LCD
(40,90)
(50,50.4)
(60,27.7)
40 50 60
CHUNGHWA PICTUER TUBES, LTD.
Page: 5/24
www.yslcd.com.twDatasheetpdf-http://www.DataSheet4U.co.kr/
5 Page 
CHUNGHWA PICTUER TUBES, LTD.
TECHNICAL SPECIFICATION
Title：CLAA154WB08A
Technical Specification
Doc. No：
Version：
Issue Date ：
V1
2007/06/26
*3) Definition of the lamp life time：
a. Luminance (L) under 50% of specification starting lamp voltage
b. Starting Lamp Voltage: over130% of the initial value. Ta=25℃
*4) For keeping good lighting situation, when design the inverter, it must be considered that the voltage
large than starting lamp voltage.
4. Connector Interface PIN & Function
(a) CN1 (Interface signal)
Outlet connector: FI-XB30SL-HF10 (JAE)
Link connector: FI-X30H (JAE, Link Type)
(Note) DDC: Display Data Requirements
www.DataSheet.net/
(Note) Refer to page6、7、8、9之 Data Mapping
Pin No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
SYMBOL
Vss
Vin
Vin
V_EDID
BIST
CLK_EDID
DATA_EDID
R0N
R0P
Vss
R1N
R1P
Vss
R2N
R2P
Vss
RCLKN
RCLKP
Vss
NC
FUNCTION
Ground
+3.3V Power
+3.3V Power
DDC 3.3V Power
Build in self-test pattern 0 Normal operation
1 Test pattern mode
DDC Clock
DDC Data
minus signal of channel 0(LVDS)
plus signal of channel 0(LVDS)
Ground
minus signal of channel 1(LVDS)
plus signal of channel 1(LVDS)
Ground
minus signal of channel 2(LVDS)
plus signal of channel 2(LVDS)
Ground
minus signal of clock channel (LVDS)
plus signal of clock channel (LVDS)
Ground
No connect
CHUNGHWA PICTUER TUBES, LTD.
Page: 11/24
www.yslcd.com.twDatasheet pdf - http://www.DataSheet4U.c
11 Page | ||
| Páginas | Total 24 Páginas | |
| PDF Descargar | [ Datasheet CLAA154WB08AD.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| CLAA154WB08A | Display Module | CHUNGHWA PICTURE TUBES |
| CLAA154WB08AD | Display Module | CHUNGHWA PICTURE TUBES |
| CLAA154WB08AN | Display Module | CHUNGHWA PICTURE TUBES |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |