|
|
Número de pieza | V370H1-L0A | |
Descripción | TFT LCD Module | |
Fabricantes | CHI MEI | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de V370H1-L0A (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
No Preview Available ! Global LCD Panel Exchange Center
www.panelook.com
Issued Date: Oct.03, 2005
Model No.: V370H1-L0A
Preliminary
TFT LCD Preliminary Specification
MODEL NO.: V370H1 - L0A
LCD TV Division
AVP ພၼ
QRA Dept.
Approval
ຫةԫ
Liquid Crystal Display Division
DDIII
Approval
TVHD/PDD
DDII
Approval
ޕޫ
៴֮ᙘ
DDI
Approval
֮ࣥᜣ
LCD TV Marketing and Project Management Dept.
Product Manager
ܦ֮ޘ
1
The information described in this technical specification is tentative and it is possible to be changed without prior
notice. Please contact CMO ’s representative while your product design is based on this specification. Version1.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
1 page Global LCD Panel Exchange Center
www.panelook.com
Issued Date: Oct.03, 2005
Model No.: V370H1-L0A
Preliminary
2. ABSOLUTE MAXIMUM RATINGS
2.1 ABSOLUTE RATINGS OF ENVIRONMENT
Item
Storage Temperature
Operating Ambient Temperature
Shock (Non-Operating)
Vibration (Non-Operating)
Symbol
TST
TOP
SNOP
VNOP
Value
Min. Max.
-20 +60
0 50
- 50
- 1.0
Note (1) Temperature and relative humidity range is shown in the figure below.
Unit Note
ºC (1)
ºC (1), (2)
G (3), (5)
G (4), (5)
(a) 90 %RH Max. ( Ta Љ 40 ºC ).
(b) Wet-bulb temperature should be 39 ºC Max. ( Ta > 40 ºC ).
(c) No condensation.
Note (2) The maximum operating temperature is based on the test condition that the surface temperature of
display area is less than or equal to 60 ºC with LCD module alone in a temperature controlled chamber.
Thermal management should be considered in your product design to prevent the surface temperature
of display area from being over 60 ºC. The range of operating temperature may degrade in case of
improper thermal management in your product design.
Note (3) 11 ms, half sine wave, 1 time for ± X, ± Y, ± Z.
Note (4) 10 ~ 200 Hz, 10 min, 1 time each X, Y, Z.
Note (5) At testing Vibration and Shock, the fixture in holding the module has to be hard and rigid enough so that
the module would not be twisted or bent by the fixture. The module would not be twisted or bent by the
fixture.
Relative Humidity (%RH)
100
90
80
60
Operating Range
40
20
10 Storage Range
-40 -20
0 20 40
Temperature (ºC)
60 80
5
The information described in this technical specification is tentative and it is possible to be changed without prior
notice. Please contact CMO ’s representative while your product design is based on this specification. Version1.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
5 Page Global LCD Panel Exchange Center
www.panelook.com
Issued Date: Oct.03, 2005
Model No.: V370H1-L0A
Preliminary
Note (5) The power supply capacity should be higher than the total inverter power consumption PBL. Since
the pulse width modulation (PWM) mode was applied for backlight dimming, the driving current
changed as PWM duty on and off. The transient response of the power supply should be
considered for the changing loading when inverter dimming.
3.2.3 INVERTER INTERTFACE CHARACTERISTICS
Parameter
Symbol
Test
Condition
Min.
Value
Typ.
Max.
Unit
Note
On/Off Control Voltage ON
OFF
VBLON
Ё
Ё
2.0 Ё 5.0 V
0 Ё 0.8 V
Internal PWM Control MAX
Voltage
MIN
VIPWM
Ё
Ё Ё 3.0 V maximum duty ratio
Ё 0 Ё V minimum duty ratio
Control Signal Rising Time
Tr Ё Ё Ё 100 ms
Control Signal Falling Time
Tf Ё Ё Ё 100 ms
Input impedance
BLON Delay Time1
BLON Off Time1
RIN
Ton1
Toff1
Ё
Ё
Ё
1 Ё Ё MӨ
1 Ё Ё ms
1 Ё Ё ms
Note (1) The power sequence and control signal timing are shown in the following figure.
Note (2) The power sequence and control signal timing must follow the figure below. For a certain reason,
the inverter has a possibility to be damaged with wrong power sequence and control signal timing.
11
The information described in this technical specification is tentative and it is possible to be changed without prior
notice. Please contact CMO ’s representative while your product design is based on this specification. Version1.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
11 Page |
Páginas | Total 30 Páginas | |
PDF Descargar | [ Datasheet V370H1-L0A.PDF ] |
Número de pieza | Descripción | Fabricantes |
V370H1-L01 | LCD_Module | CHIMEI |
V370H1-L02 | TFT LCD | CHIMEI |
V370H1-L03 | TFT LCD | CHI MEI |
V370H1-L0A | TFT LCD Module | CHI MEI |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |