DataSheet.es    


PDF AK1575 Data sheet ( Hoja de datos )

Número de pieza AK1575
Descripción Up Converter Mixer
Fabricantes AKM 
Logotipo AKM Logotipo



Hay una vista previa y un enlace de descarga de AK1575 (archivo pdf) en la parte inferior de esta página.


Total 35 Páginas

No Preview Available ! AK1575 Hoja de datos, Descripción, Manual

[AK1575]
Up Converter Mixer with
AK1575
Fractional-N Frequency Synthesizer and VCO
1. Overview
AK1575 is the up-converter mixer with fractional-N frequency synthesizer and integrated VCO.
AK1575 is targeted at the application that requires a high linearity performance in frequency
conversion. The mixer block is comprised of the differential input and the differential output. Input
frequency range is from 20MHz to 500MHz and output frequency range is from 690MHz to 4000MHz.
The current consumption and the analog performance can be adjusted by a resistance connected to
BIAS pin. The power supply voltage of mixer covers 4.75 to 5.25V.
The local signal output frequency range is from 262.5MHz to 4400MHz generated by internal VCO,
synthesizer and divider. Not only a local signal is supplied to an internal mixer, but also can be taken
to outside. A power supply voltage range of VCO/synthesizer is 2.7V to 3.6V or 4.75V to 5.25V.
The CPU interface is 24bit serial data and its voltage is ranging from 2.7V to 5.25V
General
RF output frequency Range
IF input frequency Range
LO frequency Range
Supply Voltage :
Current Consumption:
Package:
Operating Temperature :
2. Features
690MHz to 4.0GHz
20MHz to 500MHz
262.5MHz to 4.4GHz
4.75V to 5.25 V (Mixer)
2.7 to 3.6V / 4.75 to 5.25V (Synthesizer /VCO)
150mA typ.
32pin QFN (0.5mm pitch, 5mm 5mm 0.85mm)
-40°C ~ 85°C
Synthesizer/VCO
Normalized Phase Noise
Phase Noise
-218dBc/Hz
-111dBc/Hz @100kHz fo=2.1GHz
Mixer (frf=2GHz)
Conversion Gain
Input 3rd orders intercept point
Noise Figure
-1.5dB typ.
+24dBm typ.
13dB typ.
Application
Microwave Radio Link
Cellular BTS / Repeater
MS1552-E-00
1
2013/8
http://www.Datasheet4U.com

1 page




AK1575 pdf
[AK1575]
No Name
30 TEST1
31 TEST2
32 REFIN
I/O Pin function
Test enable
DI A logic low on this pin test mode the
device.
Test enable
DI A logic low on this pin test mode the
device.
AI Reference Input
Power
Down
Remarks
Pull Down
Schmidt trigger input
Pull Down
Schmidt trigger input
Note 1) The exposed pad at the center of the backside should be connected to ground.
The following table shows the meaning of abbreviations used in the “I/O” column above.
AI:Analog input pin AO:Analog output pin AIO:Analog I/O pin DI:Digital input pin
DO:Digital output pin P: Power supply pin G:Ground pin
2. Pin Assignments
24 23 22 21 20 19 18 17
25 16
26 15
27 14
28
33
29
13
12
30 11
31 10
32 9
123 456 78
32pin QFN (0.5mm pitch, 5mm x 5mm)
Fig. 2 Package Pin Layout (Top View)
MS1552-E-00
5
2013/8

5 Page





AK1575 arduino
[AK1575]
9. Block Functional Descriptions
Operation Mode
AK1575 operation is controlled as follows by the [PDN] pin and registers.
Pin Registers
Operating state
Function
[PDN] {MIXEN} MODE[1] MODE[2] Mixer Synthesizer VCO Local Out
StandBy1 L
X
X
X OFF OFF OFF OFF
Prohibited H
0
0
0 OFF ON
ON OFF
Func1 H
0
0
1 OFF ON
ON Output
Func2 H
0
1
0 OFF ON OFF Input
StandBy2 H
0
1
1 OFF OFF OFF OFF
Func3 H
1
0
0 ON ON ON OFF
Func4 H
1
0
1 ON ON ON Output
Func5 H
1
1
0 ON ON OFF Input
Func6 H
1
1
1 ON OFF OFF Input
StandBy1:Stand-by mode. Current consumption is minimized. It is available to write to the registers.
Func1: VCO and Synthesizer are active and Local signal outputs from [LOP] and [LON] pins.
Func2:Only Synthesizer is active. PLL operation is available with the external VCO.
StandBy2: Stand-by mode. Current consumption is minimized. It is available to write to the registers.
Func3: VCO, Synthesizer and Mixer are active.
Func4: VCO, Synthesizer and Mixer are active and Local signal outputs from [LOP] and [LON] pins.
Func5: Synthesizer and Mixer are active. PLL operation is available with the external VCO.
Func6: Only Mixer is active. A local signal needs to be input from [LOP] and [LON] pins.
MS1552-E-00
11
2013/8

11 Page







PáginasTotal 35 Páginas
PDF Descargar[ Datasheet AK1575.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
AK1572Down Converter MixerAKM
AKM
AK1573Frequency SynthesizerAKM
AKM
AK1573BFrequency SynthesizerAKM
AKM
AK1573CFrequency SynthesizerAKM
AKM

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar