SP330E Datasheet PDF - EXAR
| Part Number | SP330E | |
| Description | RS-232/RS-485/RS-422 TRANSCEIVER | |
| Manufacturers | EXAR | |
| Logo |  |
|
|
There is a preview and SP330E download ( pdf file ) link at the bottom of this page. Total 23 Pages | ||
Preview 1 page No Preview Available !
SP330E
RS-232/RS-485/RS-422 TRANSCEIVER WITH 1.65V-5.5V INTERFACE
November 2013
Rev. 1.0.0
GENERAL DESCRIPTION
The SP330 is an advanced multiprotocol transceiver
supporting RS-232, RS-485, and RS-422 serial
standards and featuring a variable low voltage logic
interface, down to 1.65V. Full operation requires only
four external charge pump capacitors.
The RS-485/RS-232 mode pin selects RS-485 mode
when high, and RS-232 mode when low. In RS-485
mode the HALF/FULL pin configures the transceiver
as either half or full duplex.
The high speed drivers operate up to 20Mbps in RS-
485/422 modes, and up to 1Mbps in RS-232 mode.
All drivers can be slew limited to 250kbps in any
mode to minimize electromagnetic interference (EMI)
by setting the dedicated SLEW pin low.
All transmitter outputs and receiver inputs feature
robust electrostatic discharge (ESD) protection to
±15kV IEC 61000-4-2 Airgap, ±15kV Human Body
Model (HBM) and ±8kV IEC 61000-4-2 Contact. Each
receiver output has full fail-safe protection to avoid
system lockup, oscillation, or indeterminate states by
defaulting to logic-high output level when the inputs
are open, shorted, or terminated but undriven. No
external biasing resistors are required.
The RS-232 receiver inputs include a 5k pull-down
to ground when in RS-232 mode. The RS-485/422
receiver inputs are high impedance (>96k), allowing
up to 256 devices on a single communication bus
(1/8th unit load).
The SP330 operates from a single power supply,
either 3.3V or 5V, with low idle current. The shutdown
mode consumes less than 1µA in low power standby
operation with RS-232 receivers enabled.
ORDERING INFORMATION
FEATURES
Robust ESD Protection:
■ ±15kV IEC 61000-4-2 Air Gap Discharge
■ ± 8kV IEC 61000-4-2 Contact Discharge
■ ±15kV Human Body Model (HBM)
20Mbps RS-485 and 1Mbps RS-232 Data Rates
Pin-Selectable 250kbps Slew Limiting
Single Supply Operation from +3V to +5.5V
1.65V to 5.5V Logic Interface VL pin
2 Drivers, 2 Receivers RS-232/V.28
1 Driver, 1 Receiver RS-485/422
■ Full or Half Duplex Configuration
■ 1/8th Unit Load, up to 256 receivers on bus
RS-485/422 Enhanced Receiver Fail-safe for open,
shorted, or terminated but idle inputs
10nA Shutdown Supply Current (typical)
Small 24 TSSOP package
TYPICAL APPLICATIONS
Software Programmable Serial Ports
(RS-232, RS-422, RS-485)
Industrial and Single Board Computers
Industrial and Process Control Equipment
Point-Of-Sale Equipment
HVAC Controls and Networking Equipment
Building Security and Automation
PART NUMBER
SP330EEY-L
SP330EEY-L/TR
PACKAGE
24-pin TSSOP
24-pin TSSOP
OPERATING TEMPERATURE RANGE
-40°C to +85°C
-40°C to +85°C
DEVICE STATUS
Active
Active
NOTE: SP330EEY-L and SP330EEY-L/TR are Green / RoHS Compliant
Exar Corporation 48720 Kato Road, Fremont CA, 94538 • (510) 668-7000 • FAX (510) 668-7017 • www.exar.com
http://www.Datasheet4U.com
|
| |
 
SP330E
REV. 1.0.0
RS-232/RS-485/RS-422 TRANSCEIVER WITH 1.65V-5.5V INTERFACE
ELECTRICAL CHARACTERISTICS (Continued)
UNLESS OTHERWISE NOTED:
VCC = +3.0V to +5.5V, C1-C4 = 0.1µF; TA = TMIN to TMAX. Typical values are at VCC = 3.3V, TA = +25°C.
SYMBOL
PARAMETERS
MIN. TYP. MAX. UNITS
CONDITIONS
RS-485/422 DIFFERENTIAL RECEIVER INPUTS (A,B)
RIN Receiver Input Resistance
96
IIN Receiver Input Current
VTH
VTH
Receiver Differential
Threshold Voltage
Receiver Input Hysteresis
-200
-125
25
125
-100
-50
k -7V VCM +12V
µA VIN = +12V
µA VIN = -7V
mV -7V VCM +12V
mV
RS-485/422 DIFFERENTIAL DRIVER OUTPUTS (Y, Z)
1.5
VOD Differential Driver Output
1.5
2
VOD
Change In Magnitude of
Differential Output Voltage
VCM
VCM
Driver Common Mode Output Voltage
Change In Magnitude of
Common Mode Output Voltage
IOSD
Driver Output Short Circuit Current
IO Driver Output Leakage Current
VCC
VCC
VCC
0.2
3
0.2
±250
±125
V RL = 54 (RS-485), Figure 4
V -7V VCM +12V, Figure 5
V RL = 100 (RS-422), Figure 4
V RL = 54 or 100, Figure 4
V RL = 54 or 100, Figure 4
V RL = 54 or 100, Figure 4
mA -7V VY or VZ +12V, Figure 6
DE = 0V or SHDN = 0V,
µA VY or VZ = -7V or +12V,
VCC = 0V or 5.5V
5
http://www.Datasheet4U.com
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for SP330E electronic component. |
| Information | Total 23 Pages | |
| Link URL | [ Copy URL to Clipboard ] | |
| Download | [ SP330E.PDF Datasheet ] | |
Share Link :
Electronic Components Distributor
|
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
| SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
| Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
| Part Number | Description | Manufacturers |
| SP330E | The function is RS-232/RS-485/RS-422 TRANSCEIVER. | EXAR |
Semiconductors commonly used in industry:
1N4148 |
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
SP33
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA | ||