|
|
Número de pieza | STRW6053S | |
Descripción | Current Mode Control PWM Regulator IC | |
Fabricantes | Sanken | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de STRW6053S (archivo pdf) en la parte inferior de esta página. Total 12 Páginas | ||
No Preview Available ! STR-W605xS
Current Mode Control PWM Regulator IC
For Switching Power Supplies
Features and Benefits
▪ TO-220F power package with 30 to 90 W power output
▪ Current Mode PWM control
▪ Built-in Random Switching function, reducing EMI noise,
and simplifying EMI filters, and therefore reducing cost
▪ Built-in Slope Compensation function, avoiding
subharmonic oscillation
▪ Built-in Auto Standby function (Input Power, PIN < 30 mW
at no load)
▫ Normal operation: PWM mode
▫ Light load operation: Standby mode (burst oscillation)
▪ Built-in Audible Noise Suppression function during
Standby mode
▪ Built-in Startup Circuit, reducing power consumption in
standby operation, and eliminating external components.
▪ Bias-Assist function, improving startup operation,
suppressing VCC voltage drop in operation, and allowing
use of smaller VCC capacitor
▪ Built-in Leading Edge Blanking function
Continued on the next page…
Package: 6-Pin fully molded
TO-220F-6L (FM207)
Description
The STR-W605xS series are power ICs for switching power
supplies, incorporating a power MOSFET and a current mode
PWM controller IC. Including a startup circuit and a standby
function in the controller, the product achieves low power
consumption, low standby power, and high cost-effectiveness
power supply systems with few external components.
The STR-W605xS internal MOSFEThas aVDSS of 650V(min),
and an RDS(on) of 1.9 Ω (max) to 3.95 Ω (max) with a frequency
of 67 kHz. Power output is rated at 45 to 90 W at 230 VAC
input and 30 to 60 W at wide input range (85 to 265 VAC).
The device is provided in an industry-standardTO-220 package,
with heatsink mounting flange and pin 2 removed for increased
supply isolation.
Applications:
For switching power supplies used in:
• White goods
• Consumer electronics
• Office automation
• Industrial equipmenthttp://www.DataSheet4U.net/
• Communication equipment
Not to scale
Typical Application
VAC
VOU T
STR-W605xS-DS
STR-W6000S
1 34567
GND
Brown-In/Brown-Out function
disabled by connecting BR
terminal to GND.
datasheet pdf - http://www.DataSheet4U.net/
1 page STR-W605xS
Current Mode Control PWM Regulator IC
For Switching Power Supplies
Electrical Characteristics1 Valid at VCC = 18 V, TA = 25°C, unless otherwise specified
Characteristic
Symbol Terminal Min.
Operation Start Voltage
Operation Stop Voltage2
Circuit Current in Operation
Minimum Startup Voltage
Startup Current
Startup Current Supply Threshold Voltage2
Average Switching Frequency
Switching Frequency Variance Range
VCC(ON)
VCC(OFF)
ICC(ON)
VST(ON)
ISTARTUP
VCC(BIAS)
fOSC(av)
∆f
4–5
4–5
4–5
4–5
4–5
4–5
1–5
1–5
13.8
7.3
–
–
–3.9
8.5
60
–
Maximum Duty Cycle
DMAX
1–5
Leading Edge Blanking Time
tBW –
OCP Compensation Coefficient
DPC
–
Maximum Duty Cycle for OCP Compensation
DDPC
–
OCP Threshold Voltage at Zero Duty Cycle
VOCP(L)
3–5
OCP Threshold Voltage at 36% Duty Cycle
VOCP(H)
3–5
Maximum Feedback Current
IFB(MAX)
6–5
Minimum Feedback Current
IFB(MIN)
6–5
Oscillation Stop FB/OLP Voltage
VFB(OFF)
6–5
OLP Threshold Voltage
VFB(OLP)
6–5
Operation Current After OLP
ICC(OLP)
4–5
OLP Delay Time
tOLP
http://www.DataSheet4U.net/
1–5
FB/OLP Terminal Clamp Voltage
VFB(CLAMP)
6–5
Brown-In Threshold Voltage
VBR(IN)
7–5
Brown-Out Threshold Voltage
VBR(OUT)
7–5
BR Terminal Clamp Voltage
VBR(CLAMP)
7–5
BR Function Disabling Threshold
VBR(DIS)
7–5
OVP Threshold Voltage
VCC(OVP)
4–5
Thermal Shutdown Operating Temperature
TJ(TSD)
–
1Current characteristics are defined based on IC as sink ( +), or source ( –).
2VCC(BIAS) > VCC(OFF).
63
–
–
–
0.70
0.79
–340
–30
0.85
7.3
–
54
11
5.2
4.45
6
0.3
26
130
Typ.
15.3
8.1
–
40
–2.5
9.5
67
5
71
390
18
36
0.78
0.88
–230
–15
0.95
8.1
300
68
12.8
5.6
4.8
6.4
0.48
29
–
Max.
16.8
8.9
2.5
–
–1.1
10.5
74
–
79
–
–
–
0.86
0.97
–150
–7
1.05
8.9
–
82
14
6
5.15
7
0.7
32
–
MOSFET Electrical Characteristics Valid at TA = 25°C, unless otherwise specified
Characteristic
Symbol
Device
Terminal Min.
Typ.
Max.
Unit
Drain-to-Source Breakdown Voltage
Drain Leakage Current
VDSS
IDSS
–
–
STR-W6051S
1–3
1–3
1–3
650
–
–
– –V
– 300 μA
– 3.95 Ω
On-Resistance
RDS(on)
STR-W6052S
STR-W6053S
1–3
1–3
–
–
– 2.8 Ω
– 1.9 Ω
Switching Time
tf – 1 – 3
STR-W6051S
–
–
–
– 250 ns
– 2.63 °C/W
Thermal Resistance*
RθchF
STR-W6052S
–
–
– 2.26 °C/W
STR-W6053S
–
–
– 1.95 °C/W
*Between channel and internal frame.
Unit
V
V
mA
V
mA
V
kHz
kHz
%
ns
mV/μs
%
V
V
μA
μA
V
V
μA
ms
V
V
V
V
V
V
°C
datasheet pdf - http://www.DataSheet4U.net/
5 Page STR-W605xS
Current Mode Control PWM Regulator IC
For Switching Power Supplies
Packing Specifications
4.8
+0.4
0
1.4
5.1
9 × R0.6
Tube dimensions (mm)
2.85
(3.6)
Side marked
“ANTISTATIC”
1.3
+0.3
–0.2
14.3
Carton
(side
view)
Spacer
http://www.DataSheet4U.net/
Tube
125
620
Spacer
Carton dimensions (mm)
Capacity:
36 tubes per carton (3 rows, 12 tubes per row)
50 pieces per tube
1800 pieces maximum per carton
185
Tube
datasheet pdf - http://www.DataSheet4U.net/
11 Page |
Páginas | Total 12 Páginas | |
PDF Descargar | [ Datasheet STRW6053S.PDF ] |
Número de pieza | Descripción | Fabricantes |
STRW6053S | Current Mode Control PWM Regulator IC | Sanken |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |