DataSheet39.com

What is CY7C68013A?

This electronic component, produced by the manufacturer "Cypress Semiconductor", performs the same function as "EZ-USB FX2LP USB Microcontroller High-Speed USB Peripheral Controller".


CY7C68013A Datasheet PDF - Cypress Semiconductor

Part Number CY7C68013A
Description EZ-USB FX2LP USB Microcontroller High-Speed USB Peripheral Controller
Manufacturers Cypress Semiconductor 
Logo Cypress Semiconductor Logo 


There is a preview and CY7C68013A download ( pdf file ) link at the bottom of this page.





Total 30 Pages



Preview 1 page

No Preview Available ! CY7C68013A datasheet, circuit

CY7C68013A, CY7C68014A
CY7C68015A, CY7C68016A
EZ-USB® FX2LP™ USB Microcontroller
High-Speed USB Peripheral Controller
EZ-USB FX2LP™ USB Microcontroller High Speed USB Peripheral Controller
Features
USB 2.0 USB IF Hi-Speed certified (TID # 40460272)
Single-chip integrated USB 2.0 transceiver, smart SIE, and
enhanced 8051 microprocessor
Fit-, form-, and function-compatible with the FX2
Pin-compatible0
Object-code-compatible
Functionally compatible (FX2LP is a superset)
Ultra-low power: ICC no more than 85 mA in any mode
Ideal for bus- and battery-powered applications
Software: 8051 code runs from:
Internal RAM, which is downloaded through USB
Internal RAM, which is loaded from EEPROM
External memory device (128-pin package)
16 KB of on-chip code/data RAM
Four programmable BULK, INTERRUPT, and
ISOCHRONOUS endpoints
Buffering options: Double, triple, and quad
Additional programmable (BULK/INTERRUPT) 64-byte
endpoint
8-bit or 16-bit external data interface
Smart media standard ECC generation
GPIF™ (general programmable interface)
Enables direct connection to most parallel interfaces
Programmable waveform descriptors and configuration
registers to define waveforms
Supports multiple ready (RDY) inputs and control (CTL)
outputs
Integrated, industry-standard, enhanced 8051
48-MHz, 24-MHz, or 12-MHz CPU operation
Four clocks per instruction cycle
Two USARTs
Three counter/timers
Expanded interrupt system
Two data pointers
3.3-V operation with 5-V tolerant inputs
Vectored USB interrupts and GPIF/FIFO interrupts
Separate data buffers for the setup and data portions of a
CONTROL transfer
Integrated I2C controller; runs at 100 or 400 kHz
Four integrated FIFOs
Integrated glue logic and FIFOs lower system cost
Automatic conversion to and from 16-bit buses
Master or slave operation
Uses external clock or asynchronous strobes
Easy interface to ASIC and DSP ICs
Available in commercial and industrial temperature grades
(all packages except VFBGA)
Features (CY7C68013A/14A only)
CY7C68014A: Ideal for battery-powered applications
Suspend current: 100 A (typ)
CY7C68013A: Ideal for nonbattery-powered applications
Suspend current: 300 A (typ)
Available in five Pb-free packages with up to 40 GPIOs
128-pin TQFP (40 GPIOs), 100-pin TQFP (40 GPIOs), 56-pin
QFN (24 GPIOs), 56-pin SSOP (24 GPIOs), and 56-pin
VFBGA (24 GPIOs)
Features (CY7C68015A/16A only)
CY7C68016A: Ideal for battery-powered applications
Suspend current: 100 A (typ)
CY7C68015A: Ideal for nonbattery-powered applications
Suspend current: 300 A (typ)
Available in Pb-free 56-pin QFN package (26 GPIOs)
Two more GPIOs than CY7C68013A/14A enabling additional
features in the same footprint
For a complete list of related resources, click here.
Errata: For information on silicon errata, see “Errata” on page 65. Details include trigger conditions, devices affected, and proposed workaround.
Cypress Semiconductor Corporation • 198 Champion Court
Document Number: 38-08032 Rev. *Y
• San Jose, CA 95134-1709 • 408-943-2600
Revised June 28, 2016

line_dark_gray
CY7C68013A equivalent
CY7C68013A, CY7C68014A
CY7C68015A, CY7C68016A
Applications
Portable video recorder
MPEG/TV conversion
DSL modems
ATA interface
Memory card readers
Legacy conversion devices
Cameras
Scanners
Wireless LAN
MP3 players
Networking
The “Reference Designs” section of the Cypress web site
provides additional tools for typical USB 2.0 applications. Each
reference design comes complete with firmware source and
object code, schematics, and documentation. Visit
www.cypress.com for more information.
Functional Overview
USB Signaling Speed
FX2LP operates at two of the three rates defined in the USB
Specification Revision 2.0, dated April 27, 2000:
Full speed, with a signaling bit rate of 12 Mbps
High speed, with a signaling bit rate of 480 Mbps
FX2LP does not support the Low Speed signaling mode of
1.5 Mbps.
8051 Microprocessor
The 8051 microprocessor embedded in the FX2LP family has
256 bytes of register RAM, an expanded interrupt system, three
timer/counters, and two USARTs.
8051 Clock Frequency
FX2LP has an on-chip oscillator circuit that uses an external
24-MHz (±100 ppm) crystal with the following characteristics:
Parallel resonant
Fundamental mode
500-W drive level
12-pF (5% tolerance) load capacitors
An on-chip PLL multiplies the 24-MHz oscillator up to 480 MHz,
as required by the transceiver/PHY; internal counters divide it
down for use as the 8051 clock. The default 8051 clock
frequency is 12 MHz. The clock frequency of the 8051 can be
changed by the 8051 through the CPUCS register, dynamically.
Figure 1. Crystal Configuration
C1 24 MHz C2
12 pF
12 pF
20 × PLL
12-pF capacitor values assume a trace capacitance
of 3 pF per side on a four-layer FR4 PCA
The CLKOUT pin, which can be three-stated and inverted using
internal control bits, outputs the 50% duty cycle 8051 clock, at
the selected 8051 clock frequency: 48 MHz, 24 MHz, or 12 MHz.
USARTs
FX2LP contains two standard 8051 USARTs, addressed through
Special Function Register (SFR) bits. The USART interface pins
are available on separate I/O pins, and are not multiplexed with
port pins.
UART0 and UART1 can operate using an internal clock at
230 KBaud with no more than 1% baud rate error. 230 KBaud
operation is achieved by an internally derived clock source that
generates overflow pulses at the appropriate time. The internal
clock adjusts for the 8051 clock rate (48 MHz, 24 MHz, and
12 MHz) such that it always presents the correct frequency for
the 230-KBaud operation.[1]
Special Function Registers
Certain 8051 SFR addresses are populated to provide fast
access to critical FX2LP functions. These SFR additions are
shown in Table 1 on page 6. Bold type indicates nonstandard,
enhanced 8051 registers. The two SFR rows that end with “0”
and “8” contain bit-addressable registers. The four I/O ports A to
D use the SFR addresses used in the standard 8051 for ports 0
to 3, which are not implemented in FX2LP. Because of the faster
and more efficient SFR addressing, the FX2LP I/O ports are not
addressable in external RAM space (using the MOVX
instruction).
I2C Bus
FX2LP supports the I2C bus as a master only at 100/400 kHz.
SCL and SDA pins have open-drain outputs and hysteresis
inputs. These signals must be pulled up to 3.3 V, even if no I2C
device is connected.
Buses
All packages, 8-bit or 16-bit “FIFO” bidirectional data bus,
multiplexed on I/O ports B and D. 128-pin package: adds 16-bit
output-only 8051 address bus, 8-bit bidirectional data bus.
Note
1. 115-KBaud operation is also possible by programming the 8051 SMOD0 or SMOD1 bits to a “1” for UART0, UART1, or both respectively.
Document Number: 38-08032 Rev. *Y
Page 5 of 69


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for CY7C68013A electronic component.


Information Total 30 Pages
Link URL [ Copy URL to Clipboard ]
Product Image
and Detail view

CY7C68013A datasheet


1. - EZ-USB FX2LP USB Microcontroller

[ Learn More ]




Download [ CY7C68013A.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
CY7C68013The function is EZ-USB FX2 USB Microcontroller High-speed USB Peripheral Controller. Cypress SemiconductorCypress Semiconductor
CY7C68013-100ACThe function is EZ-USB FX2 USB Microcontroller High-speed USB Peripheral Controller. Cypress SemiconductorCypress Semiconductor
CY7C68013-128ACThe function is EZ-USB FX2 USB Microcontroller High-speed USB Peripheral Controller. Cypress SemiconductorCypress Semiconductor

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

CY7C     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search