SPE1225 Datasheet PDF - SYNC POWER
|Description||5-Line ESD Protection Array|
There is a preview and SPE1225 download ( pdf file ) link at the bottom of this page.
Total 7 Pages
Preview 1 page
No Preview Available !
5-Line ESD Protection Array
The SPE1225 are designed by TVS array that is to protect
sensitive electronics from damage or latch-up due to ESD.
They are designed for use in applications where board
space is at a premium. SPE1225 will protect up to five
lines, and may be used on lines where the signal polarities
swing above and below ground.
SPE1225 offer desirable characteristics for board level
protection including fast response time, low operating and
clamping voltage, and no device degradation.
SPE1225 may be used to meet the immunity requirements
of IEC 61000-4-2, level 4. The small SOT-363 package
makes them ideal for use in portable electronics such as
cell phones, PDA’s, notebook computers, and digital
Cellular Handsets and Accessories
Notebooks and Handhelds
Transient protection for data lines to
IEC 61000-4-2 (ESD) ±15kV (air), ±8kV (contact)
IEC 61000-4-4 (EFT) 40A (5/50ns)
Protects five I/O lines
Working voltage: 12V
Low leakage current
Low operating and clamping voltages
PIN CONFIGURATION ( SOT-363 / SC-70 )
5-Line ESD Protection Array
Device Connection for Protection of Five Data Lines
SPE1225 is designed to protect up to five data lines. The device is connected as follows:
1. The TVS protection of five I/O lines is achieved by connecting pins 1, 3, 4, 5, and 6 to the data lines. Pin 2 is
connected to ground. The ground connection should be made directly to the ground plane for best results. The
path length is kept as short as possible to reduce the effects of parasitic inductance.
Circuit Board Layout Recommendations for Suppression of ESD
Good circuit board layout is critical for the suppression of ESD induced transients. The following guidelines are
1. Place the TVS near the input terminals or connectors to restrict transient coupling.
2. Minimize the path length between the TVS and the protected line.
www3..DMataiSnhimeeit4zUe.caollmconductive loops including power and ground loops.
4. The ESD transient return path to ground should be kept as short as possible.
5. Never run critical signals near board edges.
6. Use ground planes whenever possible.
Preview 5 Page
On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for SPE1225 electronic component.
|Information||Total 7 Pages|
|Link URL||[ Copy URL to Clipboard ]|
|Download||[ SPE1225.PDF Datasheet ]|
Share Link :
Electronic Components Distributor
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.
|SparkFun Electronics||Allied Electronics||DigiKey Electronics||Arrow Electronics|
|Mouser Electronics||Adafruit||Newark||Chip One Stop|
|SPE1225||The function is 5-Line ESD Protection Array.|
Semiconductors commonly used in industry:
Quick jump to: