AD8344 Datasheet PDF - Analog Devices
Part Number | AD8344 | |
Description | 400MHz to 1.2GHz Active Receive Mixer | |
Manufacturers | Analog Devices | |
Logo | ||
There is a preview and AD8344 download ( pdf file ) link at the bottom of this page. Total 11 Pages |
Preview 1 page No Preview Available ! www.DataSheet4U.com
Preliminary Technical Data
FEATURES
Broadband RF Port: 400 MHz – 1.2 GHz
Conversion Gain: 4 dB
Noise Figure: 11 dB
Input IP3: +24 dBm
Input P1dB: +8 dBm
LO Drive: 0 dBm
External Control of Mixer Bias for Low Power Operation
Single-ended, 50Ω RF and LO Input Ports
Single Supply Operation: 5 V @ 90 mA
Power Down Mode
Exposed Paddle Chip Scale Package: 3 x 3 mm
APPLICATIONS
Cellular Base Station Receivers
ISM Receivers
Radio Links
RF Instrumentation
GENERAL DESCRIPTION
The AD8344 is a high-performance, broadband active mixer. It
is well suited for demanding receive-channel applications that
require wide bandwidth on all ports and very low inter-
modulation distortion and noise figure.
The AD8344 provides a typical conversion gain of 3dB at
900MHz. The integrated LO driver supports a 50-Ω input
impedance with a low LO drive level, helping to minimize
external component count.
The single-ended 50-Ohm broadband RF port allows for easy
interfacing to both active devices and passive filters. The RF
input accepts input signals as large as 1.8Vpp or 9dBm (re: 50 Ω)
at P1dB.
Active Receive Mixer
400 MHz – 1.2 GHz
AD8344
VPDC PWDN EXRB COMM
12 11 10 9
COMM 13
BIAS
8 COMM
RFCM 14
7 IFOP
RFIN 15
6 IFOM
VPMX 16
5 COMM
12 34
VPLO LOCM LOIN COMM
The open-collector differential outputs provide excellent
balance, and can be used with a differential filter or IF amplifier
such as the AD8369 or AD8351. These outputs may also be
converted to a single-ended signal through the use of a
matching network or a transformer (balun). When centered on
the VPOS supply voltage, the outputs may swing +/-2Vdiff.
The AD8344 is fabricated on Analog Devices proprietary, high
performance SiGe IC process. The AD8344 is available in a 16
lead CSP package. It operates over a –40°C to +85°C
temperature range. An evaluation board is available.
Rev. PrG
Information furnished by Analog Devices is believed to be accurate and reliable.
However, no responsibility is assumed by Analog Devices for its use, nor for any
infringements of patents or other rights of third parties that may result from its use.
Specifications subject to change without notice. No license is granted by implication
or otherwise under any patent or patent rights of Analog Devices. Trademarks and
registered trademarks are the property of their respective companies.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
www.analog.com
Fax: 781.326.8703 © 2004 Analog Devices, Inc. All rights reserved.
|
|
Preliminary Technical Data
AwBwwS.DOaLtaUShTeEet4UM.cAomXIMUM RATINGS
Table 2. AD8344 Absolute Maximum Ratings
Parameter
Supply Voltage VS
RF Input Level
LO Input Level
PWDN Pin
IFOP, IFOM Bias Voltage
Min. Resistor from EXRB to COMM
Internal Power Dissipation
θJA
Maximum Junction Temperature
Operating Temperature Range
Storage Temperature Range
Lead Temperature Range (Soldering 60 sec)
Rating
5.5 V
+12 dBm
+12 dBm
5.5 V
5.5 V
2kΩ
TBD mW
TBD °C/W
125 °C
–40°C to +85°C
–65°C to +150°C
300°C
AD8344
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
Rev. PrG | Page 5 of 11
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for AD8344 electronic component. |
Information | Total 11 Pages | |
Link URL | [ Copy URL to Clipboard ] | |
Product Image and Detail view | 1. - Broadband Active Receive Mixer [ Learn More ] | |
Download | [ AD8344.PDF Datasheet ] |
Share Link :
Electronic Components Distributor
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
Part Number | Description | MFRS |
AD834 | The function is 500 MHz Four-Quadrant Multiplier. Analog Devices | |
AD8340 | The function is RF Vector Modulator. Analog Devices | |
AD8341 | The function is 1.5GHz to 2.4GHz RF Vector Modulator. Analog Devices | |
Semiconductors commonly used in industry:
1N4148 |  
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
AD83
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA |