|
|
PDF ASM162 Data sheet ( Hoja de datos )
| Número de pieza | ASM162 | |
| Descripción | (ASM161 / ASM162) uP Supervisory Circuit | |
| Fabricantes | Alliance Semiconductor | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de ASM162 (archivo pdf) en la parte inferior de esta página. Total 9 Páginas | ||
|
No Preview Available !
www.DataSheet4U.com
October 2003
ASM161 / ASM162
rev 1.0
µP Supervisory Circuit
General Description
Key Features
The ASM161 and ASM162 are cost effective, low power
supervisory circuits that monitor power supplies in
microprocessor, microcontroller and digital systems. If the
power supply drops below the reset threshold level, a reset is
asserted and remains asserted for atleast 800ms after VCC has
risen above the reset threshold. An improved manual reset
architecture gives the system designer additional flexibility.
The debounced manual reset input is negative edge triggered.
The reset pulse period generated by a MR transition is a
minimum of 800 ms and a maximum of 2 sec duration. In
addition, The MR input signal is blocked for an additional 49µS
minimum after the reset pulse ends. During the MR disable
period, the microcontroller is guaranteed a time period free of
additional manual reset signals. During this period DRAM
contents can be refreshed or other critical system tasks
undertaken. Low power consumption makes the ASM161/162
ideal for use in portable and battery operated equipments. With
3V supplies power consumption is 8µW typically and 30µW
maximum. The ASM161 has an open-drain, active-LOW
RESET output and requires an external pull-up resistor. The
ASM162 has an active HIGH RESET output.
• Edge triggered manual reset input
• single pulse output
• 49µS minimum MR disable period after reset
• CMOS/TTL logic or switch interface
• Debounced input
• Low supply current extends battery life
• 6µA / 15µA typ/max at 5.5V
• 4.5µA / 10µA typ/max at 3.6V
• Long reset period
• 0.8 sec minimum, 2 sec maximum
• Two reset polarity options
• ASM161: Active LOW, open-drain
• ASM162: Active HIGH
• Pinout matches the AS811/812
• Small 4-Pin SOT-143 package
• Two temperature ranges: 00 to 700c and -400c to +850c
Applications
• PDAs
• Appliances
• Computers and embedded controllers
• Wireless communication systems
• Battery operated and intelligent instruments
• Automotive systems
• Safety systems
Typical Operating Circuit
The ASM161/162 are offered in compact 4-pin SOT-143
packages. No external components are required to trim
threshold voltage for monitoring different supply voltages. With
six different factory set, reset, threshold ranges from 2.63V to
4.63V, the ASM161/162 are suitable for monitoring 5V, 3.6V
and 3.0V supplies. The ASM161/162 are available in
temperature ranges 00 to 700c and -400c to +850c.
Reset Threshold
Part Suffix
L
M
J
T
S
R
Voltage (V)
4.63
4.38
4.00
3.08
2.93
2.63
VCC
VCC
ASM161
(ASM162)
RESET
(RESET)
MR
GND
20k for
ASM161
only
VCC
RESET
(RESET)
µP
GND
Alliance Semiconductor
2575 Augustine Drive . Santa Clara, CA 95054 . Tel: 408.855.4900 . Fax: 408.855.4999 . www.alsc.com
Notice: The information in this document is subject to change without notice
1 page  
October 2003
ASM161 / ASM162
rev 1.0
Electrical Characteristics
Unless otherwise noted, VCC is over the full range and TA = 00 to 700c for ASM161/162 X C and TA = -400c to +850c for ASM161/
162 X E devices. Typical values at TA = 250c, VCC = 5V for L/M/J devices, VCC = 3.3V for T/S devices and VCC = 3V for R devices
Parameter
Input Voltage (VCC)
Range
Supply Current
(Unloaded)
Reset Threshold
Reset Threshold Temp
Coefficient
VCC to reset delay
Reset Pulse Width
MR Minimum Pulse
Width
MR Glitch Immunity
MR to RESET Propaga-
tion Delay
Symbol
Conditions
VCC
ICC
VTH
TCVTH
tRPW
tMR
TA = 0°C to 70°C
TA = 0°C to 70°C,
TA = -40°C to +85°C
TA = 0°C to 70°C,
TA = -40°C to +85°C
L Devices
M devices
J devices
T devices
S devices
R devices
VCC < 5.5V,
L/M/J
VCC < 3.6V,
R/S/T
TA = 25°C
Note 1
TA = 25°C
Note 1
TA = 25°C
Note 1
TA = 25°C
Note 1
TA = 25°C
Note 1
TA = 25°C
Note 1
VCC = VTH to (VTH -100mV)
TA = 0°C to 70°C
TA = -40°C to 85°C
tMD
Min Typ Max Unit
1.1 5.5 V
6 15
µA
4.5 10
4.56 4.63 4.70
4.50 4.75
4.31 4.38 4.45
4.25 4.50
3.93 4.00 4.06
3.89 4.10
3.04 3.08 3.11
V
3.00 3.15
2.89 2.93 2.96
2.85 3.00
2.59 2.63 2.66
2.55 2.70
30
ppm/
°C
20 µS
800
1400
2000
560 2240
ms
10 µS
100 ns
0.5 µs
µP Supervisory Circuit
Notice: The information in this document is subject to change without notice
5 of 9
5 Page | ||
| Páginas | Total 9 Páginas | |
| PDF Descargar | [ Datasheet ASM162.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| ASM161 | (ASM161 / ASM162) uP Supervisory Circuit | Alliance Semiconductor |
| ASM161 | uP Supervisory Circuit |  ON Semiconductor |
| ASM162 | (ASM161 / ASM162) uP Supervisory Circuit | Alliance Semiconductor |
| ASM162 | uP Supervisory Circuit | ON Semiconductor |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |