DataSheet39.com

What is 93LC76B?

This electronic component, produced by the manufacturer "Microchip Technology", performs the same function as "(93LC76A/B/C) 8K Microwire Compatible Serial EEPROM".


93LC76B Datasheet PDF - Microchip Technology

Part Number 93LC76B
Description (93LC76A/B/C) 8K Microwire Compatible Serial EEPROM
Manufacturers Microchip Technology 
Logo Microchip Technology Logo 


There is a preview and 93LC76B download ( pdf file ) link at the bottom of this page.





Total 26 Pages



Preview 1 page

No Preview Available ! 93LC76B datasheet, circuit

93AA76A/B/C, 93LC76A/B/C,
93C76A/B/C
8K Microwire Compatible Serial EEPROM
www.DataSheet4U.com
Device Selection Table
Part Number
93AA76A
93AA76B
93LC76A
93LC76B
93C76A
93C76B
93AA76C
93LC76C
93C76C
VCC Range
1.8-5.5
1.8-5-5
2.5-5.5
2.5-5.5
4.5-5.5
4.5-5.5
1.8-5.5
2.5-5.5
4.5-5.5
ORG Pin
No
No
No
No
No
No
Yes
Yes
Yes
PE Pin
No
No
No
No
No
No
Yes
Yes
Yes
Features
• Low-power CMOS technology
• ORG pin to select word size for ‘76C’ version
• 1024 x 8-bit organization ‘A’ devices (no ORG)
• 512 x 16-bit organization ‘B’ devices (no ORG)
• Program Enable pin to write-protect the entire
array (except on SOT-23 packages)
• Self-timed ERASE/WRITE cycles (including
auto-erase)
• Automatic ERAL before WRAL
• Power-on/off data protection circuitry
• Industry standard 3-wire serial I/O
• Device Status signal (READY/BUSY)
• Sequential READ function
• 1,000,000 E/W cycles
• Data retention > 200 years
• Temperature ranges supported:
- Industrial (I)
-40°C to +85°C
- Automotive (E)
-40°C to +125°C
Pin Function Table
Name
CS
CLK
DI
DO
VSS
PE
ORG
VCC
Function
Chip Select
Serial Data Clock
Serial Data Input
Serial Data Output
Ground
Program Enable
Memory Configuration
Power Supply
Word Size
8-bit
16-bit
8-bit
16-bit
8-bit
16-bit
8 or 16-bit
8 or 16-bit
8 or 16-bit
Temp Ranges
I
I
I, E
I, E
I, E
I, E
I
I, E
I, E
Packages
OT
OT
OT
OT
OT
OT
P, SN, ST, MS
P, SN, ST, MS
P, SN, ST, MS
Description
The Microchip Technology Inc. 93XX76A/B/C devices
are 8K bit, low-voltage, serial Electrically Erasable
PROMs (EEPROM). Word-selectable devices such as
the 93XX76C are dependent upon external logic
levels driving the ORG pin to set word size. For
dedicated 8-bit communication, the 93XX76A devices
are available, while the 93XX76B devices provide
dedicated 16-bit communication, available on SOT-23
devices only. A Program Enable (PE) pin allows the
user to write-protect the entire memory array.
Advanced CMOS technology makes these devices
ideal for low-power, nonvolatile memory applications.
The 93XX Series is available in standard packages
including 8-lead PDIP and SOIC, and advanced
packaging including 8-lead MSOP, 6-lead SOT-23,
and 8-lead TSSOP. Pb-free (Pure Matte Sn) finish is
also available.
Package Types (not to scale)
PDIP/SOIC
(P, SN)
SOT-23
(OT)
CS
CLK
DI
DO
1
2
3
4
8 VCC
7 PE
6 ORG
5 VSS
DO 1
VSS 2
DI 3
6 VCC
5 CS
4 CLK
TSSOP/MSOP
(ST, MS)
CS
CLK
DI
DO
1
2
3
4
8 VCC
7 PE
6 ORG
5 VSS
2004 Microchip Technology Inc.
DS21796D-page 1

line_dark_gray
93LC76B equivalent
93AA76A/B/C, 93LC76A/B/C, 93C76A/B/C
2.0 FUNCTIONAL DESCRIPTION
When the ORG* pin is connected to VCC, the (x16)
organization is selected. When it is connected to
ground, the (x8) organization is selected. Instructions,
addresses and write data are clocked into the DI pin on
the rising edge of the clock (CLK). The DO pin is
normally held in a HIGH-Z state except when reading
data from the device, or when checking the READY/
BUSY status during a programming operation. The
READY/BUSY status can be verified during an Erase/
Write operation by polling the DO pin; DO low indicates
that programming is still in progress, while DO high
indicates the device is ready. DO will enter the HIGH-Z
state on the falling edge of CS.
2.1 Start Condition
The Start bit is detected by the device if CS and DI are
both high with respect to the positive edge of CLK for
the first time.
Before a Start condition is detected, CS, CLK and DI
may change in any combination (except to that of a
Start condition), without resulting in any device
operation (READ, WRITE, ERASE, EWEN, EWDS,
ERAL or WRAL). As soon as CS is high, the device is
no longer in Standby mode.
An instruction following a Start condition will only be
executed if the required opcode, address and data bits
for any particular instruction are clocked in.
2.2 Data In/Data Out (DI/DO)
It is possible to connect the Data In and Data Out pins
together. However, with this configuration it is possible
for a “bus conflict” to occur during the “dummy zero”
that precedes the read operation, if A0 is a logic high-
level. Under such a condition the voltage level seen at
Data Out is undefined and will depend upon the relative
impedances of Data Out and the signal source driving
A0. The higher the current sourcing capability of the
driver, the higher the voltage at the Data Out pin. In
order to limit this current, a resistor should be
connected between DI and DO.
2.3 Data Protection
All modes of operation are inhibited when VCC is below
a typical voltage of 1.5V for ‘93AA’ and ‘93LC’ devices
or 3.8V for ‘93C’ devices.
The EWEN and EWDS commands give additional
protection against accidentally programming during
normal operation.
Note:
For added protection, an EWDS command
should be performed after every write
operation.
After power-up, the device is automatically in the
EWDS mode. Therefore, an EWEN instruction must be
performed before the initial ERASE or WRITE instruction
can be executed.
Block Diagram
VCC VSS
Memory
Array
Address
Decoder
DI
ORG*
CS
PE*
CLK
Data Register
Mode
Decode
Logic
Clock
Register
Address
Counter
Output DO
Buffer
*ORG and PE inputs are not available on
A/B devices.
2004 Microchip Technology Inc.
DS21796D-page 5


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for 93LC76B electronic component.


Information Total 26 Pages
Link URL [ Copy URL to Clipboard ]
Download [ 93LC76B.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
93LC76The function is 8K/16K 2.5V Microwire Serial EEPROM. Microchip TechnologyMicrochip Technology
93LC76-IPThe function is 8K/16K 2.5V Microwire Serial EEPROM. Microchip TechnologyMicrochip Technology
93LC76-ISNThe function is 8K/16K 2.5V Microwire Serial EEPROM. Microchip TechnologyMicrochip Technology

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

93LC     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search