DataSheet39.com

What is EL1503A?

This electronic component, produced by the manufacturer "Intersil Corporation", performs the same function as "High Power Differential Line Driver".


EL1503A Datasheet PDF - Intersil Corporation

Part Number EL1503A
Description High Power Differential Line Driver
Manufacturers Intersil Corporation 
Logo Intersil Corporation Logo 


There is a preview and EL1503A download ( pdf file ) link at the bottom of this page.





Total 17 Pages



Preview 1 page

No Preview Available ! EL1503A datasheet, circuit

®
Data Sheet
March 26, 2007
EL1503A
FN7039.2
High Power Differential Line Driver
The EL1503A ADSL Line Driver contains two wideband
high-voltage drivers which are ideally suited for both ADSL
and HDSL2 applications. They can supply a 39.2VP-P signal
into a 22Ω load while exhibiting very low distortion. The
EL1503A also has a number of power saving features. The
IADJ pin can be used to set the maximum supply current and
the C0 and C1 pins can be used to digitally vary the supply
current to one of four modes. These modes include full
power, low power, terminate only and power down.
The EL1503A uses current-feedback type amplifiers, which
achieve a high slew rate while consuming moderate power.
They retain their frequency response over a wide range of
externally set gains. The EL1503A operates on ±5V to ±12V
supplies and consumes only 12.5mA per amplifier.
The device is supplied in a thermally-enhanced 20 Ld SOIC
(0.300”) and the small footprint (4x5mm) 24 Ld QFN
packages. Center pins on each side of the 20 Ld and 16 Ld
packages are used as ground connections and heat
spreaders. The QFN package has the potential for a low θJA
(<40°C/W) and dissipates heat by means of a thermal pad
that is soldered onto the PCB. All package options are
www.DataSheet4U.cosmpecified for operation over the full -40°C to +85°C
temperature range.
Pinouts
EL1503A
(24 LD QFN)
TOP VIEW
NC 1
NC 2
VS- 3
NC 4
NC 5
NC 6
GND 7
THERMAL
PAD
19 NC
18 NC
17 VS+
16 NC
15 NC
14 NC
13 GND
Features
• High power ADSL driver
• 39.2VP-P differential output drive into 22Ω
• 42.4VP-P differential output drive into 65Ω
• Driver 2nd/3rd harmonics of
-66dBc/-72dBc at 2VP-P into 100Ω differential
• Supply current of 12.5mA per amplifier
• Supply current control
• Power saving modes
• Standard surface-mount packages
• Ultra-small QFN package
• Pb-free plus anneal available (RoHS compliant)
Applications
• ADSL line drivers
• HDSL2 line drivers
• Video distribution amplifiers
EL1503A
[20 LD SOIC (0.300”)]
TOP VIEW
VIN-A 1
20 VIN-B
VOUTA 2
19 VOUTB
VS- 3
GND* 4
A
18 VS+
B
17 GND*
GND* 5
16 GND*
GND* 6
15 GND*
GND* 7
14 GND*
VIN+A 8
13 VIN+B
C1 9
C0 10
POWER
CONTROL
LOGIC
12 IADJ
11 NC
*GND pins are heat spreaders
1 CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2002, 2003, 2005, 2007. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.

line_dark_gray
EL1503A equivalent
EL1503A
Typical Performance Curves (Continued)
25
RF=1.82kΩ
20
RF=2.0kΩ
VS=±12V
AV=10
RL=100Ω
RF=2.43kΩ
RF=2.74kΩ
25
VS=±5V
ARVL==11000Ω
RF=1.84kΩ
RF=2.0kΩ
20
RF=2.43kΩ
RF=2.74kΩ
15
100M
10M
1M
FREQUENCY (Hz)
100K
FIGURE 5. DRIVER DIFFERENTIAL FREQUENCY
RESPONSE vs RF (TERMINATE MODE)
19
VS=±12V
AV=5
RL=100Ω
14
RF=1.3kΩ
RF=1.5kΩ
RF=1.82kΩ
RF=2.0kΩ
RF=2.4kΩ
RF=2.74kΩ
9
100K
1M 10M
FREQUENCY (Hz)
100M
FIGURE 7. DRIVER DIFFERENTIAL FREQUENCY
RESPONSE vs RF (FULL POWER MODE)
19
VS=±12V
AV=5
RL=100Ω
14
RF=1.3kΩ
RF=1.5kΩ
RF=1.82kΩ
RF=2.0kΩ
RF=2.43kΩ
RF=2.74kΩ
9
100K
1M 10M
FREQUENCY (Hz)
100M
FIGURE 9. DRIVER DIFFERENTIAL FREQUENCY
RESPONSE vs RF (2/3 POWER MODE)
15
100K
1M 10M
FREQUENCY (Hz)
100M
FIGURE 6. DRIVER DIFFERENTIAL FREQUENCY
RESPONSE vs RF (TERMINATE MODE)
19
VS=±5V
AV=5
RL=100Ω
RF=1.5kΩ
RF=1.82kΩ
14
RF=2.0kΩ
RF=2.4k
RF=2.74k
9
100K
1M 10M
FREQUENCY (Hz)
100M
FIGURE 8. DRIVER DIFFERENTIAL FREQUENCY
RESPONSE vs RF (FULL POWER MODE)
19
VS=±5V
AV=5
RL=100Ω
14
RF=1.5kΩ
RF=1.82kΩ
RF=2.0kΩ
RF=2.4kΩ
RF=2.74kΩ
9
100K
1M 10M
FREQUENCY (Hz)
100M
FIGURE 10. DRIVER DIFFERENTIAL FREQUENCY
RESPONSE vs RF (2/3 POWER MODE)
5 FN7039.2
March 26, 2007


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for EL1503A electronic component.


Information Total 17 Pages
Link URL [ Copy URL to Clipboard ]
Download [ EL1503A.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
EL1503AThe function is High Power Differential Line Driver. Intersil CorporationIntersil Corporation
EL1503CThe function is High Power Differential Line Driver. ElantecElantec
EL1503CLThe function is High Power Differential Line Driver. ElantecElantec

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

EL15     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search