FW870 Datasheet PDF - ETC
Part Number | FW870 | |
Description | Manual | |
Manufacturers | ETC | |
Logo | ||
There is a preview and FW870 download ( pdf file ) link at the bottom of this page. Total 30 Pages |
Preview 1 page No Preview Available ! IMPORTANT SAFETY NOTICES
PREVENTION OF PHYSICAL INJURY
1. Before disassembling or assembling parts of the copier and peripherals,
make sure that the copier power cord is unplugged.
2. The wall outlet should be near the copier and easily accessible.
3. Note that some components of the copier and the paper tray unit are
supplied with electrical voltage even if the main switch is turned off.
4. If any adjustment or operation check has to be made with exterior covers
off or open while the main switch is turned on, keep hands away from
electrified or mechanically driven components.
5. The inside and the metal parts of the fusing unit become extremely hot
while the copier is operating. Be careful to avoid touching those
components with your bare hands.
6.The copier is not attached to the table. Pushing the copier too heard may
cause it to drop onto the floor. While moving the copier, push the table.
7. When the main switch is tuned on, the machine will suddenly start turning
to perform the developer initialization. Keep hans away from any
mechanical and electrical components during this period.
HEALTH SAFETY CONDITIONS
1. Never operate the copier without the ozone filters installed.
2. Always replace the ozone filters with the specified ones at the specified
intervals.
3. Toner and developer are non-toxic, but if you get either of them in your
eyes by accident, it may cause temporary eye discomfort. Try to remove
with eye drops or flush with water as first aid. If unsuccessful, get medical
attention.
OBSERVANCE OF ELECTRICAL SAFETY STANDARDS
1. The copier and its peripherals must be installed and maintained by a
customer service representative who has completed the training course
on those models.
CAUTION
2. The RAM board on the main control board has a lithium battery
which can explode if replaced incorrectly. Replace the RAM board
only with an identical one. The manufacturer recommends
replacing the entire RAM board. Do not recharge or burn this
battery. Used RAM board must be handled in accordance with
local regulations.
www.DataSheet4U.com
|
|
SPECIFICATIONS
25 July 1996
Paper Feeding:
Manual feed and 2 roll feeds
(3rd roll feeder optional)
Image Fusing:
Heat and pressure type, teflon (upper) and
silicone rubber (lower) rollers
Fusing Lamp:
Halogen lamp
(115 V: 1,100 W, 230 V: 1,100 W)
Self-diagnostic Codes:
18 codes, displayed in copy counter
Power Source:
115 V/60 Hz....12 A
220 V/50 Hz....7 A
230 V/50Hz.....7 A
240 V/50 Hz....7 A
Power Consumption:
Maximum:
Warm-up:
Ready:
Copy cycle:
1.41 kW
1.21 kW
0.1 to 1.2 kW
1.36 kW
Dimensions (W x D x H):
1230 x 690 x 1065 mm
48.4" x 27.2" x 41.9"
Weight:
195 kg, 429 lb
Optional Equipment and Machine Configuration
Configuration
Main frame Optional equipment
A174 3rd Roll feeder (A613)
copier
Side guides (A569)
Additional equipment
–
–
Other Optional Equipment
• Paper Spool (Spare parts)
• Key Counter Bracket Set (A902-15)
• Key Counter (Procured locally)
• Key Counter Holder (Procured locally)
Specifications are subject to change without notice.
1-2
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for FW870 electronic component. |
Information | Total 30 Pages | |
Link URL | [ Copy URL to Clipboard ] | |
Download | [ FW870.PDF Datasheet ] |
Share Link :
Electronic Components Distributor
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
Part Number | Description | MFRS |
FW870 | The function is Manual. ETC | |
Semiconductors commonly used in industry:
1N4148 |  
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
FW87
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA |