DataSheet39.com

What is ST62T01C?

This electronic component, produced by the manufacturer "ST Microelectronics", performs the same function as "(ST62T00C / ST62T01C / ST62T03C / ST62E01C) 8-BIT OTP/EPROM MCUs".


ST62T01C Datasheet PDF - ST Microelectronics

Part Number ST62T01C
Description (ST62T00C / ST62T01C / ST62T03C / ST62E01C) 8-BIT OTP/EPROM MCUs
Manufacturers ST Microelectronics 
Logo ST Microelectronics Logo 


There is a preview and ST62T01C download ( pdf file ) link at the bottom of this page.





Total 30 Pages



Preview 1 page

No Preview Available ! ST62T01C datasheet, circuit

ST62T00C/T01C
ST62T03C/E01C
8-BIT OTP/EPROM MCUs WITH A/D CONVERTER,
OSCILLATOR SAFEGUARD, SAFE RESET AND 16 PINS
s 3.0 to 6.0V Supply Operating Range
s 8 MHz Maximum Clock Frequency
s -40 to +125°C Operating Temperature Range
s Run, Wait and Stop Modes
s 5 Interrupt Vectors
s Look-up Table capability in Program Memory
s Data Storage in Program Memory:
User selectable size
s Data RAM: 64bytes
s User Programmable Options
s 9 I/O pins, fully programmable as:
– Input with pull-up resistor
– Input without pull-up resistor
– Input with interrupt generation
– Open-drain or push-pull output
– Analog Input (except ST62T03C)
s 3I/O lines can sink up to 20mA to drive LEDs or
TRIACs directly
s 8-bit Timer/Counter with 7-bit programmable
prescaler
s Digital Watchdog
s Oscillator Safe Guard
s Low Voltage Detector for Safe Reset
s 8-bit A/D Converter with up to 4 analog inputs
s On-chip Clock oscillator can be driven by Quartz
Crystal Ceramic resonator or RC network
s Power-on Reset
s One external Non-Maskable Interrupt
s ST626x-EMU2 Emulation and Development
System (connects to an MS-DOS PC via a
parallel port)
DEVICE SUMMARY
DEVICE
ST62T00C
ST62T01C
ST62T03C
ST62E01C
OTP
(Bytes)
1036
1836
1036
-
EPROM
(Bytes)
-
-
-
1836
I/O Pins
9
9
9
9
Analog
inputs
4
4
None
4
PDIP16
PSO16
SSOP16
CDIP16W
(See end of Datasheet for Ordering Information)
August 1999
Rev. 2.8
1/70
1

line_dark_gray
ST62T01C equivalent
ST62T00C/T01C ST62T03C/E01C
1.2 PIN DESCRIPTIONS
VDD and VSS. Power is supplied to the MCU via
these two pins. VDD is the power connection and
VSS is the ground connection.
OSCin and OSCout. These pins are internally
connected to the on-chip oscillator circuit. A quartz
crystal, a ceramic resonator or an external clock
signal can be connected between these two pins.
The OSCin pin is the input pin, the OSCout pin is
the output pin.
RESET. The active-low RESET pin is used to re-
start the microcontroller. Internal pull-up is provid-
ed at this pin.
TEST/VPP. The TEST must be held at VSS for nor-
mal operation. If TEST pin is connected to a
+12.5V level during the reset phase, the EPROM
programming Mode is entered.
NMI. The NMI pin provides the capability for asyn-
chronous interruption, by applying an external non
maskable interrupt to the MCU. The NMI input is
falling edge sensitive. The user can select as op-
tion the availability of an on-chip pull-up at this pin.
PA1-PA3. These 3 lines are organized as one I/O
port (A). Each line may be configured under soft-
ware control as inputs with or without internal pull-
up resistors, interrupt generating inputs with pull-
up resistors, open-drain or push-pull outputs. PA1-
PA3 can also sink 20mA for direct LED driving.
PB0..PB1,PB3,PB5-PB7. These 6 lines are or-
ganized as one I/O port (B). Each line may be con-
figured under software control as inputs with or
without internal pull-up resistors, interrupt generat-
ing inputs with pull-up resistors, open-drain or
push-pull outputs. PB3,PB5..-PB7 can be used as
analog inputs for the A/D converter on the
ST62T00C, T01C and E01C.
Figure 2. ST62T03C,T00C, T01C, and E01C Pin
Configuration
VDD
OSCin
OSCout
NMI
VPP/T EST
RESET
Ain*/PB7
Ain*/PB6
1
2
3
4
5
6
7
8
16 VSS
15 PA1/20 mA Sink
14 PA2/20 mA Sink
13 PA3/20 mA Sink
12 PB0
11 PB1
10 PB3/Ain*
9 PB5/Ain*
*Analog input availability depend on device
5/70
5


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for ST62T01C electronic component.


Information Total 30 Pages
Link URL [ Copy URL to Clipboard ]
Download [ ST62T01C.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
ST62T01CThe function is (ST62T00C / ST62T01C / ST62T03C / ST62E01C) 8-BIT OTP/EPROM MCUs. ST MicroelectronicsST Microelectronics

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

ST62     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search