DS005AKC Datasheet PDF - Sony
Part Number | DS005AKC | |
Description | Single-Panel Liquid Crystal Optical Engine for Rear Projectors | |
Manufacturers | Sony | |
Logo | ||
There is a preview and DS005AKC download ( pdf file ) link at the bottom of this page. Total 12 Pages |
Preview 1 page No Preview Available ! DS005AKC
Single-Panel Liquid Crystal Optical Engine for Rear Projectors
Description
The DS005AKC is a single-panel liquid crystal
optical engine for use in rear projectors, and is
capable of full-color displays without color filters (CF).
The DS005AKC employs a square pixel arrangement
optimal for data projector applications, and allows
clear graphic and character displays. Up/down and/or
right/left inversion functions accommodate various
mounting methods.
Short projection distances are made possible through
the adoption of an ultra-wide angle lens. In addition, a
projection lens floating mechanism delivers 40 to 50
type projected images with minimal image distortion.
A high intensity discharge (HID) lamp ensures high
luminance and low power consumption.
Features
• Number of active dots: 1,456,000
• Horizontal resolution: 600 TV lines
• Supports SVGA (804 × 3 × 604)/PC98∗ (804 × 3 × 500) mode display
NTSC/NTSC-WIDE/PAL/PAL-WIDE modes also available through conversion of scanned dot numbers by an
external IC
• Up/down and/or right/left inverse display function
• Full-color display with CF-less projection system
• High luminance: normally-white 200 ANSIlm (typ.)
• Ultra-wide angle lens for short projection distances (592.8mm/39.8 type)
• Image distortion correction floating mechanism to support 40 to 50 type
• Relative luminance: 70% or more
• Uses HID lamp (100W)
∗ "PC98" is a trademark of NEC Corporation.
Engine Configuration
• HID lamp
• Lamp driver (DC 300V input)
• High-efficiency illumination system employing an integrator
• Separate RGB illumination systems using dichroic mirrors (DM)
• LCD panel mounting mechanism, adjustable along XYθ axes
• LCD panel (LCX021BM)
Dots: 2412 (H) × 604 (V) = 1,456,848 dots
• Wide fixed focal length lens for enlarged projection of LCD
Applications
Liquid crystal rear projection TV/monitor
Sony reserves the right to change products and specifications without prior notice. This information does not convey any license by
any implication or otherwise under any patents or other right. Application circuits shown, if any, are typical examples illustrating the
operation of the devices. Sony cannot assume responsibility for any problems arising out of the use of these circuits.
–1–
E99942B04
|
|
DS005AKC
1. Contrast ratio
Contrast ratio (CR) is given by the following formula.
L (White): Surface illuminance of the screen at the input signal amplitude VAC = 0.5V.
L (Black): Surface illuminance of the screen at VAC = 4.5V.
Both luminances are measured by Measurement System I.
CR = L (White)/L (Black)
2. Luminous intensity
In Measurement System I, the average of the illuminance at the nine points specified in the ANSI standards
when the input signal amplitude VAC is 0.5V, multiplied by the projection area, is computed.
L = average illuminance at nine ANSI points (lm/m2) × projection area (m2)
H/3 H/3 H/3
Nine ANSI points: centers of each of the
areas obtained by dividing
the effective display area
into nine smaller areas
H
3. Chromaticity
Raster modes of each color are defined by the representations at the input signal amplitude conditions shown
in the table below. Measurement System I uses chromaticity of x and y of the CIE standards here.
Signal amplitude (VAC) applied to each input
R input
G input
B input
R 0.5 4.5 4.5
G 4.5 0.5 4.5
B 4.5 4.5 0.5
(Unit: V)
4. Color shading
In Measurement System I, the maximum values of CIE color differences at the three points in the middle row
of the nine ANSI points, measured at an input signal amplitude VAC of 0.5V, are used to compute the color
shading.
∆u'v' = (u'1 – u'2)2 + (v'1 – v2)2
For other electro-optical characteristics, see the LCX021BM specifications.
–5–
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for DS005AKC electronic component. |
Information | Total 12 Pages | |
Link URL | [ Copy URL to Clipboard ] | |
Download | [ DS005AKC.PDF Datasheet ] |
Share Link :
Electronic Components Distributor
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
Part Number | Description | MFRS |
DS005AKA | The function is Single-Panel Liquid Crystal Optical Engine for Rear Projectors. Sony | |
DS005AKC | The function is Single-Panel Liquid Crystal Optical Engine for Rear Projectors. Sony | |
Semiconductors commonly used in industry:
1N4148 |  
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
DS00
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA |