DataSheet39.com

What is M27C2001-10C1TR?

This electronic component, produced by the manufacturer "STMicroelectronics", performs the same function as "2 Mbit 256Kb x 8 UV EPROM and OTP EPROM".


M27C2001-10C1TR Datasheet PDF - STMicroelectronics

Part Number M27C2001-10C1TR
Description 2 Mbit 256Kb x 8 UV EPROM and OTP EPROM
Manufacturers STMicroelectronics 
Logo STMicroelectronics Logo 


There is a preview and M27C2001-10C1TR download ( pdf file ) link at the bottom of this page.





Total 16 Pages



Preview 1 page

No Preview Available ! M27C2001-10C1TR datasheet, circuit

M27C2001
2 Mbit (256Kb x 8) UV EPROM and OTP EPROM
s 5V ± 10% SUPPLY VOLTAGE in READ
OPERATION
s FAST ACCESS TIME: 55ns
s LOW POWER CONSUMPTION:
– Active Current 30mA at 5MHz
– Standby Current 100µA
s PROGRAMMING VOLTAGE: 12.75V ± 0.25V
s PROGRAMMING TIME: 100µs/byte (typical)
s ELECTRONIC SIGNATURE
– Manufacturer Code: 20h
– Device Code: 61h
DESCRIPTION
The M27C2001 is a high speed 2 Mbit EPROM of-
fered in the two ranges UV (ultra violet erase) and
OTP (one time programmable). It is ideally suited
for microprocessor systems requiring large pro-
grams and is organised as 262,144 by 8 bits.
The FDIP32W (window ceramic frit-seal package)
and LCCC32W (leadless chip carrier package)
have a transparent lids which allow the user to ex-
pose the chip to ultraviolet light to erase the bit pat-
tern. A new pattern can then be written to the
device by following the programming procedure.
For applications where the content is programmed
only one time and erasure is not required, the
M27C2001 is offered in PDIP32, PLCC32 and
TSOP32 (8 x 20 mm) packages.
Table 1. Signal Names
A0-A17
Address Inputs
Q0-Q7
Data Outputs
E Chip Enable
G Output Enable
P Program
VPP Program Supply
VCC Supply Voltage
VSS Ground
32
1
FDIP32W (F)
32
1
PDIP32 (B)
LCCC32W (L)
PLCC32 (K)
Figure 1. Logic Diagram
TSOP32 (N)
8 x 20 mm
VCC VPP
18
A0-A17
8
Q0-Q7
P M27C2001
E
G
VSS
AI00716B
April 1999
1/16

line_dark_gray
M27C2001-10C1TR equivalent
M27C2001
Table 7. Read Mode DC Characteristics (1)
(TA = 0 to 70 °C or –40 to 85 °C; VCC = 5V ± 5% or 5V ± 10%; VPP = VCC)
Symbol
Parameter
Test Condition
Min
ILI Input Leakage Current
ILO Output Leakage Current
ICC Supply Current
0V VIN VCC
0V VOUT VCC
E = VIL, G = VIL,
IOUT = 0mA, f = 5MHz
ICC1 Supply Current (Standby) TTL
ICC2 Supply Current (Standby) CMOS
IPP Program Current
VIL Input Low Voltage
E = VIH
E > VCC – 0.2V
VPP = VCC
–0.3
VIH (2) Input High Voltage
2
VOL Output Low Voltage
IOL = 2.1mA
Output High Voltage TTL
VOH
Output High Voltage CMOS
IOH = –400µA
IOH = –100µA
2.4
VCC – 0.7V
Note: 1. VCC must be applied simultaneously with or before VPP and removed simultaneously or after VPP.
2. Maximum DC voltage on Output is VCC +0.5V.
Max
±10
±10
30
1
100
10
0.8
VCC + 1
0.4
Unit
µA
µA
mA
mA
µA
µA
V
V
V
V
V
Table 8A. Read Mode AC Characteristics (1)
(TA = 0 to 70 °C or –40 to 85 °C; VCC = 5V ± 5% or 5V ± 10%; VPP = VCC)
M27V2001
Symbol Alt
Parameter
Test Condition -55 (3)
-70
-80
-90 Unit
Min Max Min Max Min Max Min Max
tAVQV
tACC
Address Valid to
Output Valid
E = VIL, G = VIL
55
70
80
90 ns
tELQV
tCE
Chip Enable Low to
Output Valid
G = VIL
55 70 80 90 ns
tGLQV
tOE
Output Enable Low
to Output Valid
E = VIL
30 35 40 40 ns
tEHQZ (2)
tDF
Chip Enable High to
Output Hi-Z
G = VIL
0 30 0 30 0 30 0 30 ns
tGHQZ (2)
tDF
Output Enable High
to Output Hi-Z
E = VIL
0 30 0 30 0 30 0 30 ns
tAXQX
tOH
Address Transition to
Output Transition
E = VIL, G = VIL
0
0
0
0
ns
Note: 1. VCC must be applied simultaneously with or before VPP and removed simultaneously or after VPP.
2. Sampled only, not 100% tested.
3. In case of 45ns speed see High Speed AC measurament conditions.
5/16


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for M27C2001-10C1TR electronic component.


Information Total 16 Pages
Link URL [ Copy URL to Clipboard ]
Download [ M27C2001-10C1TR.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
M27C2001-10C1TRThe function is 2 Mbit 256Kb x 8 UV EPROM and OTP EPROM. STMicroelectronicsSTMicroelectronics

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

M27C     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search