EM638165TS Datasheet PDF - Etron Technology
Part Number | EM638165TS | |
Description | 4M x 16 bit Synchronous DRAM | |
Manufacturers | Etron Technology | |
Logo | ||
There is a preview and EM638165TS download ( pdf file ) link at the bottom of this page. Total 30 Pages |
Preview 1 page No Preview Available ! EtronTech
EM638165TS
Etron Confidential
4M x 16 bit Synchronous DRAM (SDRAM)
Advanced (Rev 3.2, Mar. /2012)
Features
• Fast access time from clock: 4.5/5.4/5.4 ns
• Fast clock rate: 200/166/143 MHz
• Fully synchronous operation
• Internal pipelined architecture
• 1M word x 16-bit x 4-bank
• Programmable Mode registers
- CAS Latency: 2, or 3
- Burst Length: 1, 2, 4, 8, or full page
- Burst Type: interleaved or linear burst
- Burst stop function
• Auto Refresh and Self Refresh
• 4096 refresh cycles/64ms
• CKE power down mode
• Single +3.3V ± 0.3V power supply
• Interface: LVTTL
• 54-pin 400 mil plastic TSOP II package
- Pb and Halogen Free
Overview
Table1. Key Specifications
EM638165
tCK3 Clock Cycle time(min.)
tAC3 Access time from CLK(max.)
tRAS Row Active time(min.)
tRC Row Cycle time(min.)
- 5/6/7
5/6/7 ns
4.5/5.4/5.4ns
40/42/49 ns
55/60/63 ns
Table 2. Ordering Information
Part Number Frequency Package
EM638165TS -5/5LG 200MHz TSOP II
EM638165TS -6/6LG 166MHz TSOP II
EM638165TS -7/7LG 143MHz TSOP II
TS: indicates TSOPII Package
L: indicates Lower Self Refresh current
G: indicates Pb and Halogen Free for TSOPII Package
Figure 1.Pin Assignment (Top View)
The EM638165 SDRAM is a high-speed CMOS
synchronous DRAM containing 64 Mbits. It is
internally configured as 4 Banks of 1M word x 16
DRAM with a synchronous interface (all signals are
registered on the positive edge of the clock signal,
CLK). Read and write accesses to the SDRAM are
burst oriented; accesses start at a selected location
and continue for a programmed number of locations
in a programmed sequence. Accesses begin with the
registration of a BankActivate command which is then
followed by a Read or Write command.
The EM638165 provides for programmable Read
or Write burst lengths of 1, 2, 4, 8, or full page, with a
burst termination option. An auto precharge function
may be enabled to provide a self-timed row precharge
that is initiated at the end of the burst sequence. The
refresh functions, either Auto or Self Refresh are easy
to use. By having a programmable mode register, the
system can choose the most suitable modes to
maximize its performance. These devices are well
suited for applications requiring high memory
bandwidth and particularly well suited to high
performance PC applications.
VDD
DQ0
VDDQ
DQ1
DQ2
VSSQ
DQ3
DQ4
VDDQ
DQ5
DQ6
VSSQ
DQ7
VDD
LDQM
WE#
CAS#
RAS#
CS#
BA0
BA1
A10/AP
A0
A1
A2
A3
VDD
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
54 VSS
53 DQ15
52 VSSQ
51 DQ14
50 DQ13
49 VDDQ
48 DQ12
47 DQ11
46 VSSQ
45 DQ10
44 DQ9
43 VDDQ
42 DQ8
41 VSS
40 NC/RFU
39 UDQM
38 CLK
37 CKE
36 NC
35 A11
34 A9
33 A8
32 A7
31 A6
30 A5
29 A4
28 VSS
Etron Technology, Inc.
No. 6, Technology Rd. V, Hsinchu Science Park, Hsinchu, Taiwan 30078, R.O.C.
TEL: (886)-3-5782345 FAX: (886)-3-5778671
Etron Technology, Inc. reserves the right to change products or specification without notice.
|
|
EtronTech
EM638165TS
Operation Mode
Fully synchronous operations are performed to latch the commands at the positive edges of CLK. Table 4
shows the truth table for the operation commands.
Table 4. Truth Table (Note (1), (2))
Command
State CKEn-1 CKEn DQM BA0,1 A10 A0-9,11 CS# RAS# CAS# WE#
BankActivate
Idle(3)
H
X X V Row address L L H H
BankPrecharge
Any H X X V L X L L H L
PrechargeAll
Any
H
X X XH
X
LL H L
Write
Write and AutoPrecharge
Active(3)
Active(3)
H
H
X V V L Column L H L
address
X V V H (A0 ~ A7) L H L
L
L
Read
Read and Autoprecharge
Active(3)
Active(3)
H
H
X V V L Column L H L H
address
X V V H (A0 ~ A7) L H L H
Mode Register Set
Idle H X X
OP code
LL L L
No-Operation
Any H X X X X X L H H H
Burst Stop
Active(4) H X X X X X L H H L
Device Deselect
Any H X X X X X H X X X
AutoRefresh
Idle H H X X X X L L L H
SelfRefresh Entry
Idle H L X X X X L L L H
SelfRefresh Exit
Idle L H X X X X H X X X
(SelfRefresh)
LH H H
Clock Suspend Mode Entry Active H L X X X X H X X X
LV V V
Power Down Mode Entry
Any(5)
H
L X XX
X
HX X X
LH H H
Clock Suspend Mode Exit
Active L H X X X X X X X X
Power Down Mode Exit
Any L H X X X X H X X X
(PowerDown)
LH H H
Data Write/Output Enable
Active H X L X X X X X X X
Data Mask/Output Disable
Active H X H X X X X X
Note: 1. V=Valid, X=Don't Care L=Low level H=High level
2. CKEn signal is input level when commands are provided.
CKEn-1 signal is input level one clock cycle before the commands are provided.
3. These are states of bank designated by BA signal.
4. Device state is 1, 2, 4, 8, and full page burst operation.
5. Power Down Mode can not enter in the burst operation.
When this command is asserted in the burst cycle, device state is clock suspend mode.
X
X
Etron Confidential
5
Rev 3.2
Mar. 2012
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for EM638165TS electronic component. |
Information | Total 30 Pages | |
Link URL | [ Copy URL to Clipboard ] | |
Download | [ EM638165TS.PDF Datasheet ] |
Share Link :
Electronic Components Distributor
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
Part Number | Description | MFRS |
EM638165TS | The function is 4M x 16 bit Synchronous DRAM. Etron Technology | |
Semiconductors commonly used in industry:
1N4148 |  
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
EM63
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA |