DataSheet.es    


PDF HV9910B Data sheet ( Hoja de datos )

Número de pieza HV9910B
Descripción Universal High-Brightness LED Driver
Fabricantes Microchip 
Logotipo Microchip Logotipo



Hay una vista previa y un enlace de descarga de HV9910B (archivo pdf) en la parte inferior de esta página.


Total 15 Páginas

No Preview Available ! HV9910B Hoja de datos, Descripción, Manual

HV9910B
Universal High-Brightness LED Driver
Features
• Switch mode controller for single switch LED drivers
• Enhanced drop-in replacement to the HV9910
• Open loop peak current controller
• Internal 8.0 to 450V linear regulator
• Constant frequency or constant off-time operation
• Linear and PWM dimming capability
• Requires few external components for operation
Applications
• DC/DC or AC/DC LED driver applications
• RGB backlighting LED driver
• Back lighting of flat panel displays
• General purpose constant current source
• Signage and decorative LED lighting
• Chargers
Description
HV9910B is an open loop, current mode control, LED
driver IC. This IC can be programmed to operate in
either a constant frequency or constant off-time mode.
It includes an 8.0 - 450V linear regulator which allows it
to work from a wide range of input voltages without the
need for an external low voltage supply. HV9910B
includes a PWM-dimming input that can accept an
external control signal with a duty ratio of 0 - 100% and
a frequency of up to a few kilohertz. It also includes a 0
- 250mV linear dimming input which can be used for lin-
ear dimming of the LED current.
HV9910B is ideally suited for buck LED drivers. Since
the HV9910B operates in open loop current mode con-
trol, the controller achieves good output current regula-
tion without the need for any loop compensation. PWM
dimming response is limited only by the rate of rise and
fall of the inductor current, enabling very fast rise and
fall times. HV9910B requires only three external com-
ponents, apart from the power stage, to produce a con-
trolled LED current. This makes HV9910B an ideal
solution for low cost LED drivers.
2015 Microchip Technology Inc.
DS20005344A-page 1

1 page




HV9910B pdf
HV9910B
2.0 PIN DESCRIPTION
The locations of the pins are listed in Package Type.
TABLE 2-1: PIN DESCRIPTION
Pin #
8-Lead SOIC 16-Lead SOIC
Function
Description
1 1 VIN Input of an 8.0 - 450V linear regulator.
Current sense pin used to sense the FET current by means of an
2
4
CS
external sense resistor. When this pin exceeds the lower of either
the internal 250mV or the voltage at the LD pin, the GATE output
goes low.
3
5
GND
Ground return for all internal circuitry. This pin must be electrically
connected to the ground of the power train.
4
8
GATE
Output GATE driver for an external N-channel power MOSFET.
PWM dimming input of the IC. When this pin is pulled to GND, the
5 9 PWMD GATE driver is turned off. When the pin is pulled high, the GATE
driver operates normally.
6
12
VDD
Power supply for all internal circuits.
It must be bypassed with a low ESR capacitor to GND (0.1μF).
7
13
LD
Linear dimming input and sets the current sense threshold as long
as the voltage at the pin is less than 250mV (typ).
Sets the oscillator frequency. When a resistor is connected
8
14
RT
between RT and GND, the HV9910B operates in constant fre-
quency mode. When the resistor is connected between RT and
GATE, the IC operates in constant off-time mode.
-
2, 3, 6, 7, 10,
11, 15, 16
NC No connection
2015 Microchip Technology Inc.
DS20005344A-page 5

5 Page





HV9910B arduino
HV9910B
16-Lead SOIC (Narrow Body) Package Outline (NG)
9.90x3.90mm body, 1.75mm height (max), 1.27mm pitch
D
16
θ1
Note 1
(Index Area
D/2 x E1/2)
1
Top View
A A2
A1
e
Side View
E1 E
A
Seating
Plane
b
A
L2 Gauge
Plane
L
L1
View B
h
h Note 1
Seating
θ Plane
View
B
View A-A
Note: For the most current package drawings, see the Microchip Packaging Specification at www.microchip.com/packaging.
Note:
1. 7KLVFKDPIHUIHDWXUHLVRSWLRQDO,ILWLVQRWSUHVHQWWKHQD3LQLGHQWL¿HUPXVWEHORFDWHGLQWKHLQGH[DUHDLQGLFDWHG7KH3LQLGHQWL¿HUFDQEH
DPROGHGPDUNLGHQWL¿HUDQHPEHGGHGPHWDOPDUNHURUDSULQWHGLQGLFDWRU
Symbol
A A1 A2 b D E E1 e h L L1 L2 ș ș
MIN 1.35* 0.10 1.25 0.31 9.80* 5.80* 3.80*
0.25 0.40
0O 5O
Dimension
(mm)
NOM
-
-
-
-
9.90
6.00
3.90
1.27
BSC
-
-
1.04 0.25
REF BSC
-
-
MAX 1.75 0.25 1.65* 0.51 10.00* 6.20* 4.00*
0.50 1.27
8O 15O
JEDEC Registration MS-012, Variation AC, Issue E, Sept. 2005.
7KLVGLPHQVLRQLVQRWVSHFL¿HGLQWKH-('(&GUDZLQJ
Drawings are not to scale.
2015 Microchip Technology Inc.
DS20005344A-page 11

11 Page







PáginasTotal 15 Páginas
PDF Descargar[ Datasheet HV9910B.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
HV9910Universal High Brightness LED DriverSupertex
Supertex
HV9910BUniversal High-Brightness LED DriverMicrochip
Microchip
HV9910BUniversal High Brightness LED DriverSupertex
Supertex
HV9910CUniversal High-Brightness LED DriverMicrochip
Microchip

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar