DataSheet39.com

What is IS25CD025?

This electronic component, produced by the manufacturer "ISSI", performs the same function as "256Kbit Single Operating Voltage Serial Flash Memory".


IS25CD025 Datasheet PDF - ISSI

Part Number IS25CD025
Description 256Kbit Single Operating Voltage Serial Flash Memory
Manufacturers ISSI 
Logo ISSI Logo 


There is a preview and IS25CD025 download ( pdf file ) link at the bottom of this page.





Total 30 Pages



Preview 1 page

No Preview Available ! IS25CD025 datasheet, circuit

IS25CD025
256Kbit Single Operating Voltage Serial Flash Memory
With 100 MHz Dual-Output SPI Bus Interface
FOMEueAtmpTuoUtrySRWPEIiStBhu1s0I0ntMerHfazcDe ual-
OSuintpgulet SPoPwI eBruSsuIpnptelyrfOacpeeration
-DLuoawl-vOolutatgpeurat nSgPe:I2B.7u0sVI-n3te.6r0faVce
• Low PMoweemr CoorynsWumitphti1on00 MHz
- Typical 6 mA active read current
- Typical 10 mA program/erase current
• Memory Organization
- IS25CD025: 32K x 8 (256Kbit)
• Hardware Write Protection
- Protect and unprotect the device from write
• Cost Effective Sector/Block Architecture
operation by Write Protect (WP#) Pin
-256Kb : Uniform 4KByte sectors / one uniform
32KByte blocks
• Software Write Protection
- The Block Protect (BP2, BP1, BP0) bits allow
Low standby current 10uA (Max)
• Serial Peripheral Interface (SPI) Compatible
partial or entire memory to be configured as read-
only
- Supports single- or dual-output
- Supports SPI Modes 0 and 3
- Maximum 33 MHz clock rate for normal read
- Maximum 100 MHz clock rate for fast read
• High Product Endurance
- Guaranteed 200,000 program/erase cycles per
single sector
- Minimum 20 years data retention
Page Program (up to 256 Bytes) Operation
- Typical 2 ms per page program
• Sector, Block or Chip Erase Operation
- Maximum 7 ms sector, block or chip erase
• Industrial Standard Pin-out and Package
- 8-pin SOIC 150mil
- 8-pin TSSOP
- KGD (Call Factory)
- Automotive Grades Available
- Lead-free (Pb-free) package
GENERAL DESCRIPTION
The IS25CD025 are 256Kbit Serial Peripheral Interface (SPI) Flash memories, providing single- or dual-output.
The devices are designed to support a 33 MHz clock rate in normal read mode, and 100 MHz in fast read, the
fastest in the industry. The devices use a single low voltage power supply, wide operating voltage ranging from
2.70 Volt to 3.60 Volt, to perform read, erase and program operations. The devices can be programmed in
standard EPROM programmers.
The IS25CD025 are accessed through a 4-wire SPI Interface consisting of Serial Data Input/Output (SlO), Serial
Data Output (SO), Serial Clock (SCK), and Chip Enable (CE#) pins. They comply with all recognized command
codes and operations. The dual-output fast read operation provides and effective serial data rate of 200MHz.
The devices support page program mode, where 1 to 256 bytes data can be programmed into the memory in
one program operation. These devices are divided into uniform 4 KByte sectors or uniform 32 KByte blocks.
The IS25CD025 are manufactured on pFLASH™’s advanced non-volatile technology. The devices are offered
in 8-pin SOIC 150mil and 8-pin TSSOP. The devices operate at wide temperatures between -40°C to +105°C.
Integrated Silicon Solution, Inc.- www.issi.com
Rev. G
07/31/2013
1

line_dark_gray
IS25CD025 equivalent
IS25CD025
SYSTEM CONFIGURATION
The IS25CD025 devices are designed to interface directly with the synchronous Serial Peripheral Interface (SPI)
of the Motorola MC68HCxx series of microcontrollers or any SPI interface-equipped system controllers. The
devices have two superset features that can be enabled through specific software instructions and the
Configuration Register:
Memory Density
256Kbit
Block No.
Block
Size
(KBytes)
Sector No.
Sector 0
Sector 1
Sector
Size
(KBytes)
4
4
Address Range
000000h - 000FFFh
001000h - 001FFFh
Block 0
32
:
:
:
Table 1. Block/Sector Addresses of IS25CD025
Sector 7
4 007000h - 007FFFh
Integrated Silicon Solution, Inc.- www.issi.com
Rev. G
07/31/2013
5


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for IS25CD025 electronic component.


Information Total 30 Pages
Link URL [ Copy URL to Clipboard ]
Download [ IS25CD025.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
IS25CD025The function is 256Kbit Single Operating Voltage Serial Flash Memory. ISSIISSI

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

IS25     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search