DataSheet39.com

What is C8051F360?

This electronic component, produced by the manufacturer "Silicon Laboratories", performs the same function as "Mixed Signal ISP Flash MCU Family".


C8051F360 Datasheet PDF - Silicon Laboratories

Part Number C8051F360
Description Mixed Signal ISP Flash MCU Family
Manufacturers Silicon Laboratories 
Logo Silicon Laboratories Logo 


There is a preview and C8051F360 download ( pdf file ) link at the bottom of this page.





Total 30 Pages



Preview 1 page

No Preview Available ! C8051F360 datasheet, circuit

C8051F360/1/2/3/4/5/6/7/8/9
Mixed Signal ISP Flash MCU Family
Analog Peripherals
- 10-Bit ADC (‘F360/1/2/6/7/8/9 only)
Up to 200 ksps
Up to 21 external single-ended or differential inputs
VREF from internal VREF, external pin or VDD
Internal or external start of conversion source
Built-in temperature sensor
- 10-Bit Current Output DAC
(‘F360/1/2/6/7/8/9 only)
- Two Comparators
Programmable hysteresis and response time
Configurable as interrupt or reset source
Low current (TBD µA)
- Brown-out detector and POR Circuitry
On-Chip Debug
- On-chip debug circuitry facilitates full speed, non-
intrusive in-system debug (no emulator required)
- Provides breakpoints, single stepping,
inspect/modify memory and registers
- Superior performance to emulation systems using
ICE-chips, target pods, and sockets
- Low cost, complete development kit
Supply Voltage
- Range: 2.7–3.6 V (50 MIPS) 3.0–3.6 V (100 MIPS)
(See Table 3.1)
- Power saving suspend and shutdown modes
High Speed 8051 µC Core
- Pipelined instruction architecture; executes 70% of
instructions in 1 or 2 system clocks
- 100 MIPS or 50 MIPS throughput with on-chip PLL
- Expanded interrupt handler
- 2-cycle 16 x 16 MAC engine
Memory
- 1280 bytes internal data RAM (256 + 1024)
- 32 kB (‘F360/1/2/3/4/5/6/7) or 16 kB (‘F368/9) Flash;
In-system programmable in 1024-byte Sectors—
1024 bytes are reserved in the 32 kB devices
Digital Peripherals
- up to 39 Port I/O; All 5 V tolerant with high sink cur-
rent
- Hardware enhanced UART, SMBus™, and
enhanced SPI™ serial ports
- Four general purpose 16-bit counter/timers
- 16-Bit programmable counter array (PCA) with six
capture/compare modules
- Real time clock mode using PCA or timer and exter-
nal clock source
- External Memory Interface (EMIF)
Clock Sources
- Two internal oscillators:
24.5 MHz with ±2% accuracy supports crystal-less
UART operation
80/40/20/10 kHz low frequency, low power
- Flexible PLL technology
- External oscillator: Crystal, RC, C, or clock
(1 or 2 pin modes)
- Can switch between clock sources on-the-fly; useful
in power saving modes
Packages
- 48-pin TQFP (C8051F360/3)
- 32-pin LQFP (C8051F361/4/6/8)
- 28-pin QFN (C8051F362/5/7/9)
Temperature Range: –40 to +85 °C (See
Table 3.1)
ANALOG
PERIPHERALS
VOLTAGE
+
+
COMPARATORS
-
-
A 10-bit
M
U
200 ksps
X ADC
‘F360/1/2/6/7/8/9 only
TEMP
SENSOR
10-bit
Current
DAC
DIGITAL I/O
UART
SMBus
Port 0
SPI
PCA
Port 1
Timer 0
Timer 1
Port 2
Timer 2
Timer 3
Port 3
Port 3
48-pin only
Port 4
HIGH-SPEED CONTROLLER CORE
WDT
16 x 16
MAC
8051 CPU
(100 or 50 MIPS)
1024 B
SRAM
POR
FLEXIBLE
DEBUG Internal Oscillator / 32/16 KB
INTERRUPTS CIRCUITRY
LFO / PLL
ISP FLASH
Rev. 0.2 1/07
Copyright © 2007 by Silicon Laboratories
C8051F36x
This information applies to a product under development. Its characteristics and specifications are subject to change without notice.

line_dark_gray
C8051F360 equivalent
C8051F360/1/2/3/4/5/6/7/8/9
13.3.2.16.4.2 PSWE Maintenance .................................................................... 147
13.3.3.System Clock ......................................................................................... 147
13.4.Flash Read Timing ......................................................................................... 149
14. Branch Target Cache ........................................................................................... 151
14.1.Cache and Prefetch Operation ....................................................................... 151
14.2.Cache and Prefetch Optimization................................................................... 152
15. External Data Memory Interface and On-Chip XRAM........................................ 159
15.1.Accessing XRAM............................................................................................ 159
15.1.1.16-Bit MOVX Example ........................................................................... 159
15.1.2.8-Bit MOVX Example ............................................................................. 159
15.2.Configuring the External Memory Interface .................................................... 160
15.3.Port Configuration........................................................................................... 160
15.4.Multiplexed and Non-multiplexed Selection.................................................... 163
15.4.1.Multiplexed Configuration....................................................................... 163
15.4.2.Non-multiplexed Configuration............................................................... 164
15.5.Memory Mode Selection................................................................................. 165
15.5.1.Internal XRAM Only ............................................................................... 165
15.5.2.Split Mode without Bank Select.............................................................. 165
15.5.3.Split Mode with Bank Select................................................................... 166
15.5.4.External Only.......................................................................................... 166
15.6.Timing .......................................................................................................... 166
15.6.1.Non-multiplexed Mode ........................................................................... 168
15.6.2.Multiplexed Mode ................................................................................... 171
16. Oscillators ............................................................................................................. 175
16.1.Programmable Internal High-Frequency (H-F) Oscillator ............................... 175
16.1.1. Internal Oscillator Suspend Mode ......................................................... 176
16.2.Programmable Internal Low-Frequency (L-F) Oscillator ................................ 177
16.2.1.Calibrating the Internal L-F Oscillator..................................................... 178
16.3.External Oscillator Drive Circuit...................................................................... 178
16.4.System Clock Selection.................................................................................. 179
16.5.External Crystal Example ............................................................................... 181
16.6.External RC Example ..................................................................................... 182
16.7.External Capacitor Example ........................................................................... 182
16.8.Phase-Locked Loop (PLL).............................................................................. 183
16.8.1.PLL Input Clock and Pre-divider ............................................................ 183
16.8.2.PLL Multiplication and Output Clock ...................................................... 183
16.8.3.Powering on and Initializing the PLL ...................................................... 184
17. Port Input/Output.................................................................................................. 189
17.1.Priority Crossbar Decoder .............................................................................. 191
17.2.Port I/O Initialization ....................................................................................... 193
17.3.General Purpose Port I/O ............................................................................... 196
18. SMBus ................................................................................................................... 209
18.1.Supporting Documents ................................................................................... 210
18.2.SMBus Configuration...................................................................................... 210
Rev. 0.2
5


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for C8051F360 electronic component.


Information Total 30 Pages
Link URL [ Copy URL to Clipboard ]
Download [ C8051F360.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
C8051F360The function is Mixed Signal ISP Flash MCU Family. Silicon LaboratoriesSilicon Laboratories
C8051F361The function is Mixed Signal ISP Flash MCU Family. Silicon LaboratoriesSilicon Laboratories
C8051F362The function is Mixed Signal ISP Flash MCU Family. Silicon LaboratoriesSilicon Laboratories

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

C805     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search