DataSheet39.com

What is SM7.5?

This electronic component, produced by the manufacturer "MIC", performs the same function as "TVS Diode, SMD (Transient Voltage Suppressor)".


SM7.5 Datasheet PDF - MIC

Part Number SM7.5
Description TVS Diode, SMD (Transient Voltage Suppressor)
Manufacturers MIC 
Logo MIC Logo 


There is a preview and SM7.5 download ( pdf file ) link at the bottom of this page.





Total 4 Pages



Preview 1 page

No Preview Available ! SM7.5 datasheet, circuit

SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR
SM6.8 THRU SM200CA
Breakdown Voltage
Peak Pulse Power
6.8 to 200 Volts
400 Watts
FEATURES
Plastic package has Underwriters Laboratory
Flammability Classification 94V-O
For surface mounted applications
Glass passivated junction
Low inductance surge resistance
Fast response time: typical less than 1.0ps
from 0 volts to V(BR) for unidirectional AND 5.0ns for
bidirectional types
400W peak pulse capability with a 10/1000μs waveform,
repetition rate (duty cycle): 0.01%
For devices with V(BR) 10V, ID are typically less than 1.0μA
High temperature soldering guaranteed:
250/10 seconds at terminals
DO-213AB
Dimensions in inches and (millimeters)
MECHANICAL DATA
Cass: JEDEC DO-213AB,molded plastic body over passivated junction
Terminals: Solder plated, solderable per MIL-STD-750, Method 2026
Polarity: Blue bands denotes positive end (cathode) for unidirectional and yellow band in the
Middle for bidirectional types
Mounting position: any
Weight: 0.116 ounces, 0.0064 gram
DEVICES FOR BIDRECTIONAL APPLICATIONS
For bidirectional applications use suffix letters C or CA for types SM6.8 thru SM200A (e.g. SM6.8C,
SM200CA).Electrical Characteristics apply in both directions.
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25ambient temperature unless otherwise specified
Ratings
Symbols
Peak Pulse power dissipation with a 10/1000μs waveform(NOTE1,FIG.1)
Steady Stage Power Dissipation at TT=75(Note2)
Peak Pulse current with a 10/1000μs waveform (NOTE1,FIG.3)
Peak forward surge current, 8.3ms single half
sine-wave superimposed on rated load for unidirectional only
(JEDEC Method) (Note3)
Maximum instantaneous forward voltage at 25A (NOTE 3)
for unidirectional only
Operating Junction and Storage Temperature Range
PPPM
PM(AV)
IPPM
IFSM
VF
TJ, TSTG
Value
Minimum 400
1.0
See Table 1
40.0
3.5
50 to +150
Unit
Watts
Watt
Amps
Amps
Volts
Notes:
1. Non-repetitive current pulse, per Fig.3 and derated above TA=25per Fig.2
2. Mounted on copper pads to each terminal of 0.31 in (8.0mm2) per Fig 5.
3. Measured at 8.3ms single half sine-wave or equivalent square wave duty cycle = 4 pulses per minutes maximum.
E-mail: [email protected] Web Site: www.cnmic.com


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for SM7.5 electronic component.


Information Total 4 Pages
Link URL [ Copy URL to Clipboard ]
Download [ SM7.5.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
SM7.5The function is TVS Diode, SMD (Transient Voltage Suppressor). MICMIC
SM7.5AThe function is TVS Diode, SMD (Transient Voltage Suppressor). MICMIC

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

SM7.     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search